Red Seal Online Review Questions Flashcards
When using a powder-activated tool, what is done if a cartridge misfire occurs?
Keep Tool in place wait 30 seconds re-fire tool
What is the best suited fastening device to use when applying a stop block to a jig
Screw & Glue
What are the first steps when machining a haunched mortise and tenon joint on a prototype?
Machine the tenon then mortise
What is the procedure to layout the cut-out for a kitchen sink?
Lay out template where required and follow where to cut
Which sequence of cutters and cutting operations is used on a tenoner when coped shoulders are required?
Tenon heads
Coping Heads
Cut off Saw
On a multi-spindle dovetailing machine, what will lowering the cutters by 1 mm do?
It will make a looser joint at the pins and tails
What is used to prevent mitre joints from opening?
Kiln dried lumber and sufficient glue
Which steps are necessary when doing a large production run on CNC equipment?
Regularly check dimensions of finished products and make adjustments.
What is the best concealed method to curve the end of a straight piece of wood
Kerf cuts across the grain for the length of the curve.
What is the procedure when building a 3/4 in. thick laminated panel?
Rip, face, edge, plane to 7/8 in., then glue.
What is the best suited substrate for a high gloss laminate on a display wall?
MDF
What is the main consideration when performing a plastic laminate take-off for a kitchen?
Sheet Size & Waste
Which combination of edges and application procedure is most suitable when putting an edge on a shop-made countertop?
Solid surface, plastic laminate or solid wood with suitable glue.
What must be done when applying a decorative solid wood edging to the top of a chest of drawers?
Apply edge to top, sand flush, then router profile.
What results from excessive pressure being applied when contact cementing plastic laminate to the face of a fir plywood core?
Telegraphing may occur
