Q 106-140 Flashcards
When optimizing a multi-arc VMAT plan, an achievable dose gradient between the target and a
nearby critical organ at risk is on the order of _____%/mm.
A. 0.05
B. 0.1
C. 1
D. 10
E. 50
D. 10
The dose uniformity to the patient _____ if an extended distance total body irradiation (TBI)
treatment is moved closer to the linac, e.g., due to a move from a large vault to a small vault.
A. increases
B. decreases
C. remains the same
D. It could be better or worse depending on other parameters.
B. decreases
The advantage of using a bilateral beam arrangement over an AP/PA beam arrangement for total
body irradiation (TBI) is _____.
A. the arms partially shield the lungs
B. more uniform dose to the patient
C. increased need for tissue compensation
D. All of the above are true.
E. None of the above is true.
A. the arms partially shield the lungs
A radionuclide injection used to treat bone metastasis from prostate cancer is \_\_\_\_\_. A. Ir-192 B. Pd-103 C. Ra-223 D. I-125 E. I-131
C. Ra-223
Which of the following intraoperative radiotherapy (IORT) delivery methods will typically result
in the greatest depth of penetration and best dose homogeneity in the treatment area?
A. electrons
B. HDR afterloader
C. kilovoltage photons
D. All of the above are similar
A. electrons
A cyclotron bombards stable nuclei with protons, typically producing \_\_\_\_\_ radioisotopes that decay via \_\_\_\_\_. A. short-lived; β– decay B. short-lived; positron emission C. long-lived; β– decay D. long-lived; positron emission E. long-lived; α decay
B. short-lived; positron emission
_____ is typically prioritized during SBRT treatment planning.
A. Rapid dose fall-off outside of the PTV
B. Dose homogeneity within the PTV
C. Limiting the number of treatment beams (or degrees of arc)
D. Ensuring sufficient margin in the beam’s-eye view between the PTV and the edge of the
field
E. All of the above are true.
A. Rapid dose fall-off outside of the PTV
Performing cranial SRS treatment planning directly on an MRI scan, rather than a CT scan, has the
DISADVANTAGE of _____.
A. inferior visualization of soft tissue targets
B. inability to localize target with sub-millimeter precision
C. increasing uncertainty in image registration for target delineation
D. lack of heterogeneity corrections for dose calculations
E. All of the above are true.
D. lack of heterogeneity corrections for dose calculations
Consider two linac-based SBRT plans, each normalized such that 100% corresponds to the dose to
the isocenter in the center of the target. Plan A is prescribed 21 Gy to the 90% isodose line. Plan B
is prescribed 18 Gy to the 80% isodose line. Which of the following is FALSE?
A. The hot spot for Plan A is greater than that of Plan B.
B. Outside the target, the dose for plan B will fall off faster than for plan A.
C. Plan B has a hot spot of 22.5 Gy.
D. The volume receiving 20 Gy will be greater in Plan A.
E. The hot spot for both plans is a point corresponding to the 100% isodose
B. Outside the target, the dose for plan B will fall off faster than for plan A.
For SRS, the Conformity Index was defined by the RTOG as a ratio of the _____, and the desired
ratio is _____.
A. volume covered by the prescribed dose to the target volume; less than 1
B. volume covered by the prescribed dose to the target volume; between 1 and 1.5
C. volume covered by the prescribed dose to the target volume; between 2 and 2.5
D. target volume to the volume covered by the prescribed dose; between 1 and 2
E. target volume to the volume covered by the prescribed dose; between 2 and 2.5
B. volume covered by the prescribed dose to the target volume; between 1 and 1.5
When developing end-to-end tests for SRS/SBRT commissioning, which aspect of the treatment process should be considered? A. simulation B. treatment planning C. treatment delivery D. All of the above are true. E. None of the above is true.
D. All of the above are true.
The anisotropy of the dose distribution around brachytherapy line sources is caused by _____.
A. the inverse square law
B. radioactive decay
C. uncertainty of source calibration
D. attenuation and scattering in the source and encapsulation
E. the photon spectrum of the source
D. attenuation and scattering in the source and encapsulation
An HDR plan was created using a 3-cm-diameter vaginal cylinder. A plan using a 3.5-cm-diameter
cylinder but normalized to deliver the same dose to the reference point 5 mm from the cylinder
surface would deliver _____.
A. the same dose to the cylinder surface
B. less dose to the cylinder surface
C. more dose to the cylinder surface
D. It depends on the length of the cylinder.
E. There is insufficient information given to determine this.
B. less dose to the cylinder surface
The American Brachytherapy Society guidelines for 3D planning for HDR cervical brachytherapy
describe that the dose should be specified in terms of _____.
A. maximum tolerance of the ICRU rectum point
B. maximum tolerance of the ICRU bladder point
C. D90 of the target volume
D. point A
E. point B
C. D90 of the target volume
All of the following isotopes are used for permanent prostate implants EXCEPT _____.
A. Pd-103
B. I-125
C. Cs-131
D. Ir-192
E. All of the above are used for permanent prostate implants
D. Ir-192