Practice Q's - Etherchannel Flashcards

1
Q

Which three combinations of PAgP allow the formation of a channel? (Choose three.)

  1. auto-desirable
  2. on-off
  3. on-on
  4. desirable-desirable
  5. on-desirable
A

Correct Answer: ACD

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Which four modes of PAgP are valid? (Choose four.)

  1. passive
  2. off
  3. on
  4. auto
  5. desirable
  6. active
A

Correct Answer: BCDE

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

A question about PAgP mode that is receiving but will not initiate formation of EtherChannel.

  1. auto
  2. desirable
  3. on
  4. off
A

Correct Answer: A

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Which command must be configured on the physical ports of a Layer 3 EtherChannel?

  1. ip address <subnet></subnet>
  2. switchport trunk encapsulation dot1q
  3. no switchport
  4. switchport mode access
A

Correct Answer: C

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

Which statement about the connection of two switches with several links using LACP link aggregation on IOS is true?

  1. By default, when an LACP channel is configured, the LACP channel mode is off.
  2. By default, when an LACP channel is configured, the LACP channel mode is on
  3. By default, when an LACP channel is configured, the LACP channel mode is active.
  4. By default, when an LACP channel is configured, the LACP channel mode is passive.
A

Correct Answer: D

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Refer to the exhibit. A single server in company ABC is connected via EtherChannel to a single upstream Layer 2 switch. Which EtherChannel load balancing methods on the switch make optimal use of the redundant links as traffic flows from the router that is the default gateway to the server?

  1. destination IP address
  2. destination MAC address
  3. source MAC address
  4. source IP address
A

Correct Answer: B

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Refer to the exhibit. A single server in Company 123 is connected via EtherChannel to a single upstream switch. Which EtherChannel load balancing method on the switch makes optimal use of the redundant links as traffic flows from the routers to the server?

  1. source MAC address
  2. source IP address
  3. source and destination MAC address
  4. destination MAC address
A

Correct Answer: A

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

If all devices on an EtherChannel are sending traffic to a single MAC address, which two methods of load balancing on the EtherChannel are preferred? (Choose two.)

  1. source-MAC
  2. src-dst-MAC
  3. destination-IP
  4. destination-MAC
  5. source-IP
A

Correct Answer: BE

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Which two statements about configuring EtherChannel are true? (Choose two.)

  1. They can be configured to passively negotiate a channel with a connected peer.
  2. They can be configured with the no switchport command to place them in Layer 3 mode.
  3. They can be configured to load-balancing traffic based on Layer 7 information.
  4. They can be configured to operate with up to 10 links in a single channel.
  5. They can be configured to send Layer 2 packets.
A

Correct Answer: AB

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

In which EtherChannel mode does a port receive and respond to PAgP message without initiating EtherChannel communication?

  1. desirable
  2. active
  3. on
  4. auto
A

Correct Answer: D

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Which type of load balancing is most appropriate for an EtherChannel that passes traffic from multiple sources to a single end device?

  1. destination MAC address forwarding
  2. source MAC address forwarding
  3. source and destination IP address forwarding
  4. destination IP address forwarding
A

Correct Answer: A

How well did you know this?
1
Not at all
2
3
4
5
Perfectly