Pneumatics Flashcards
What are the two safety valves fitted to the compressor? And what kpa are they set at?
- between compressor and air dryers 1100
- between air dryers and MR 1050
What do the levelling valves do?
Inflate or deflate the air bags according to passenger loads
Where and how many leveling valves are there
M car - 1 per bogie
T car - 2 on bogie 1 and 1 on bogie 2
What brakes are there? (4)
- service
- holding
- Emergency
- park brake
What type of brakes does the service brake use?
ED and EP
T cars only use one type of brake, what is it?
EP friction brakes
When does the holding brake apply?
0/coast
Holding BC pressure?
110
B6 pressure?
189
Emy BC pressure?
280
Main res operating pressure?
850 - 1000
Emergency brake uses what only?
EP friction brake
When does the park brake apply? (2)
- When the key is turned off
- when MR falls below 350
Park brakes are on which wheels?
3 and 7 of each car
What percentage of braking effort does ED braking have to fall below before dropping out during wheel slip? What piece of equipment decides this?
90% and EP takes over and the TCU does this
How do you reset ED braking during wheel slip?
Into coast or any powering position for min 1 sec before moving to a brake position
The sanders don’t operate when… (3)
- powering
- ED braking
- speed below 5km
Compressed air is supplied to what equipment? (6)
MR
Aux res
Surge res
Whistle
Service (friction) brake
Park brake
Air suspension equipment? (3)
Levelling valves
Air bags
Surge res