Onan Mobile Genset

Question 1

An on an mobile gen set, model 7.5HDKAL-1C is used to power the ____ volt lighting

Answer 1

110 volt

Question 2

The genset controls a are located in 3 locations;
1.
2.
3.

Answer 2

1. Switch on generator
   2.control box inside the left compartment
   3.switches located on the dash board of tractor cab

Question 3

On an model number(2003) (2006-2009) (pierce)

Answer 3

7.5HDKAL-1C
7.5HDKAL-1E
7.5HDKAL-1B

Question 4

On an genset;
Ac volts-
KVA-
Kw-
Amps-
Hz-
RPM-

Answer 4

Ac volts- 120/240
KVA-7.5
Kw-7.5
Amps-31
Hz-60
RPM- 1800

Question 5

Cord reel contains ___ ‘ of electrical cord with 2 ___ amp receptacles

Answer 5

200
20 amp

Question 6

On an The electrical panel located _____. The electrical panel consists of ___ circuit breakers.

Answer 6

In the left compartment ;12

Question 7

On an genset; keep a no load operation to a minimum . Why

Answer 7

Combustion chamber temperature drop to the point where the fuel does not burn completely, causing slobbering and white smoke.

Question 8

When stopping the genset , let it cool down by running at no-load for ___ to ___ min

Answer 8

3 to 5 min

Question 9

LTI Onan access -2
Pierce accessed

Answer 9

From the lid on top of chassis compartment
Right door on chassis compartment

Driver side rear tractor compartment
Passenger side rear mounted tractor compartment
Rear mounted access doors and floor gate

Question 10

Onan used to power; x3

Answer 10

Lighting
Electrical outlets
Battery charger on the apparatus

Question 11

Generator controls x6

Answer 11

Start /stop
Pre heat
Oil pressure gauge
Temperature gauge
Volts gauge
Hour meter

Question 12

Genset can power x5

Answer 12

Air cushion fans
Submersible pump
Water vacuum
Lights
Other appliances

Question 13

Cranking engine
Do not crank engine for more than ___ seconds at a time.
Wait __ minutes before attempting to start again

Answer 13

15; w min

Question 14

06’ GLC ( generator logic control)
Depending upon how the control is set, the generator will start when either the ____ or ___

Answer 14

Battery voltage becomes to low, or time of day for auto start has occurred

Question 15

06 GLC (Generator logic control)

Auto; Will start when batteries are below ____ volts and will run until the battery voltage has exceeded ___ volts for one hour.
When running in auto the ___ symbol will illuminate.

When starting the generator, the generator logic control will crank the generator for ___ sec and retry again after ___ sec. If after the ____ attempt the generator does not start “____” will flash on display

Answer 15

12.1/ 13.3
Lightning bolt

5 sec/ 5sec/ 5th attempt