OM.A 8.4 All weather operations Flashcards

1
Q

What is the minima for a cat 1 approach ? And required rvr

A

200ft Dh, rvr 550m/if reported 125m/if reported 75m

Multiple RVR are not required for CAT I and CAT I LTS

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What is the minima for a cat 2 approach ? And required rvr

A

100ft, rvr 300m/125m/75m

If roll out guidance used mi point RVR required is 75m

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What is the minima for a SA cat 2 approach ? And required rvr

A

100ft 350m/125m/75m

If roll out guidance used mi point RVR required is 75m

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What is the minima for a cat 3 with DH approach ? And required rvr

A

50ft, rvr 175m/125m/75m

If roll out guidance used mi point RVR required is 75m

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What is the minima for a cat 3 without DH approach ? And required rvr

A

No dh or 25ft, rvr 75/75m/75M

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Lowest rvr a captain can take off in LVP

A

125m rvr

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Required Visual References for CAT I approach ?

A

One of the following visual ref :

  • Elements of the approach light system.
  • The threshold.
  • The threshold markings.
  • The threshold lights.
  • The threshold identification lights.
  • The visual glideslope indicator.
  • The touchdown zone or touchdown zone markings.
  • The touchdown zone lights runway edge lights.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

Required visual ref for CAT II or SA CAT II ?

A

The visual references must contain a segment of at least 3 consecutive lights being :

  • The centre light of the approach lights, or
  • Touchdown zone lights, or
  • Runway centre line lights, or
  • Runway edge lights, or
  • A combination of these.

And a lateral element of the ground pattern:
* An approach lighting crossbar, or
* The landing threshold, or a barrette of the touchdown zone lighting.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Required visual ref for CAT III with DH ?

A

For Cat III with DH operations with fail-passive flight control systems, a pilot may not continue an approach below DH unless a visual reference containing at least 3 consecutive lights being:

  • The centreline of the approach lights, or
  • The touchdown zone lights, or
  • The runway centre line lights, or
  • The runway edge lights, or
  • A combination of these is attained and can be maintained.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What is the minimum RVR for Takeoff ?

A

First officer 550M

Captain 125M

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

How many consecutive approaches can be flown ?

A

No more than 2 approaches when go-around due to weather conditions unless there has been a significant improvement to the weather which would allow a safe landing, or a state of emergency exists.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

What is the approach Ban ?

A

An instrument approach may be commenced regardless of the reported RVR/VIS. If the reported RVR/VIS is less than the applicable minimum the approach shall not be continued:

  • Below 1000ft above aerodrome
  • or Into the final approach segment in the case where the DA/H or MDA/H is more than 1000 ft above the aerodrome.

In case of no reported RVR and reported VIS is less than the minimum but CMV is higher or equal to the minimum then approach can be continued to DA/H or MDA/H

thanks for the correction George

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What is the controlling RVR ?

A

The controlling RVR is the TDZ for approach with MDA, DA or DH. If the TDZ RVR is not reported, then the midpoint RVR should be the controlling RVR.

When No RVR reported => CMV should be used for continuation of approach except in LVO.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

On a CATIII without DH can you land if only one RVR is reported on the airport (can be on the opposite side of the Airport)

A

For CAT III without DH, Air Ops requires only one RVR value on the airport.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

What is the relevant RVR on Take off and on landing ?

A

NOT APPLICABLE TO AUSTRIAN AOC ONLY UK

Take-off

RVR for that part of the runway used to accelerate to V1 followed by a rejected take-off and deceleration down to a speed of approximately 60 knots.

Landing

RVR for that part of the runway used during the high speed phase of the landing run down to a speed of approximately 60 knots.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Can we fly SA CAT I ?

A

Easyjet Europe does NOT hold the approval

17
Q

The reported RVR value for takeoff is less than the required value for the initial part of the takeoff run, can the takeoff be started ? if yes how ?

A

The reported RVR value representative of the initial part of the take-off run can be replaced by pilot assessment. OMA Note 8.1.3.3
So if the number of centerline lights allows the pilot to determine a higher than required vis the take off can be started (centerline lights are spaced with 15m, edge 60m)

18
Q

What are the consequences on the required RVR to use rollout guidance for landing ?

A

the mid point RVR is reduced to 75m instead of 125M
OMA 8.1.3.3.1

19
Q

When are you allowed to used converted met vis to RVR ?

A

If an RVR is not available a CMV may be substituted for the RVR except for:

  • Takeoff minima or
  • Continuation of an approach in LVO

For planning purposes, a factor of 1.0 should be used. Which mean it cannot be used to improve the vis using a factor at planning stage.

OMA 8.1.3.5

20
Q

What is required on ground and in the A/C to perform an automatic rollout ?

A
  • Cat II ground equipment
  • NWS and antiskid
  • Not approved on contaminated RWY
21
Q

What are the consequences of the loss of one engine for a low visibility approach ?

A

The aircraft become Cat III with DH so only CAT 3 single on the FMA

Autoland in config FULL only for A320, Config 3/FULL for A319 and neo

22
Q

What is the height of the Alert Height ?

A

100ft

23
Q

What does Fail operational mean ?

A

It means that in case of a failure below the AH the A/C can do the approach, flare and landing automatically

Failure above AH, the A/C become fail passive

24
Q

What does fail passive mean ?

A

It means that in case of a failure below alert height there is no significant out of trim condition or deviation on flight path but the landing cannot be completed automatically

25
Q

What are the required Wx for a visual approach ?

A

Vis 5000m

Ceiling 2500ft

26
Q

What is the minimum wx for FO to do a circling approach ?

A

Mini vis 5000m

27
Q

What are the required visual references for circling approach ?

A

runway environment: threshold, approach light or other marking on aerodrome

28
Q

What are the required visual references for RNAV approach ?

A

Runway environment (unless specified on chart, eg. FNC)

29
Q

What is the lowest RVR you can take off without LVP ?

A

550m

30
Q

Ground equipment fail during the approach, what are the associated consequences and following actions ?

A

if the failure happen below 1000ft you can continue, above you need to asset if you can or not continu.

31
Q

What are the 5 kind of approach possible ?

A

• instrument approach to minima
• Instrument approach converted to a visual straight-in
(RVR not less than 800m)
• instrument approach to a circling procedure
• Visual approach : min 5 km vis and 2500 ft aal cloud ceiling

32
Q

What are the three CAT 1 approach possible ?

A

• ILS (CAT 1)
• RNP (LPV)
• PAR