Numbers Flashcards
How long must you wait to reset your trip?
5 seconds
At what speed does the holding brake apply?
0.5 km/h and below
The safety loop opens when your main res gets how low?
580kPa
Electric power the Static Inverters put out?
400V AC
How long do the emergency lights stay on for after a stable?
15 minutes
How much kPa is needed to gain traction during a rescue?
480kPa
At what speed will the xtrap only use the EP brake? (in normal running)
Less than 5km/h
When the PEI is pressed, how long until it times out?
90 seconds
How many positions on the EMS?
5
Minimum voltage to power an xtrap?
90v DC (Battery charge)
After stabling a train how long do you wait before removing your key?
5 seconds
When rescuing, at what BP pressure will the safety loop open?
300 and below
What is the normal main res operating pressure?
750 - 900 kPa
How long will the doors remain open if a driver doesn’t close them?
60 seconds
How much voltage runs through the low voltage equipment?
24v AC/DC
What is the time given for a driver to complete a post maintenance prep for 6 and 3 car trains?
60 minutes for a 6 car
30 minutes for a 3 car
How much power runs through the safety loop?
110v DC
How long will the battery last for if there is a loss of overhead power?
60 minutes, ish.
How much power does the battery charger output?
110v
What key do you need to get into the drivers cabin?
29p key
What is the holding brake pressure?
120 kPa
What is the emergency brake pressure?
210 kPa
What is the full service EP pressure?
190 kPa
Which wheels/axels are the spring park brakes on?
Wheels - 1, 3 & 7
Axles - 1, 2 & 3
What speeds do the ED and EP brakes blend? (in normal running)
5-10km/h
At what pressure will the safety valve open?
980kPa
How many seconds until the MAD button makes that annoying noise?
30 seconds
What voltage runs to the GPO(General Purpose Outlet)?
220vAC
How many seconds until the Auto Vigilence button flashes?
30 seconds
When doing the Panto test, the pantos should drop in less than?
10 seconds
At what pressure will 2 air compressors become active?
650kPa
How many seconds does the Auto Vigilence flash for before breaking the safety loop?
10 seconds
How long must you be stationary to reset the VICERS?
10 seconds
At what temp do you not stable a train?
25 and up
When attending to a wheelchair, how long will the doors remain open?
Which doors?
10 minutes
Doors 1,2,5 & 6
When arriving to attatch, how far do you stop from the other 3 car consist?
1 metre
At which doors are the DERs located?
2 & 5
Where are the external door releases on a motor/trailer car? (Errderrr)
Motor - 1,2,5 & 6
Trailer - 5 & 6
Which circuit breakers open the safety loop?
23Q1 & 23Q2
Which circuit breaker is pressed to make a 6 car consist think it’s a 3 car?
22Q6
(I wrote this question poorly)
How long do you get to complete a 3 and 6 car Mainline prep?
6 car - 37 minutes
3 car - 20minutes
How long is given to complete a pre-movement/revenue prep?
6 car - 18 minutes
3 car - 10 minutes
How many air compressors on a Trailer car?
2
How many SIVs in an Aux Inverter?
2
After the Pantos raise, how long before the Aux and battery charger fault lights should come off?
20 seconds
How much kPa variance is allowed?
+/- 20
How many Pantos on a 6 car train, xtrap?
2
On a 6 car consist, how many HVACs are there?
12
Which number on the EMS is the Online holding brake inhibit?
1
Which end is the lead cab shafenberg coupler on?
1