Natural Gas and CO: Policy 804 28.09.15 Flashcards

1
Q

How is natural gas distributed?

A

Through a system of high pressure (85 bar) pipelines to local distribution zones medium pressure (25 bar) which then goes to smaller distribution sites where the supply is staged down to lower pressure for domestic use. It is at this point that the stenching agent ethyl mercaptan is added so leaks are easily detectable.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Who has legal responsibility for natural gas leaks including CO and natural gas safety?

A

Gas Authority (GA)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What are the hazards of a 25-85 bar pressure jet of gas?

A
  • Physical mechanical damage to surroundings and people. Loud jet like noise.
  • Large fireball/jet flame causing oxygen starvation and asphyxiation.
  • Significant radiated heat.
  • Large unignited release could present explosion risk in open air if confined or congested.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What is an easy way of identifying a natural gas distribution site?

A

Large gas holders.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

How long can it take to turn off the high pressure system at a natural gas distribution site?

A

Up to an hour as the natural gas has to be staged down to prevent a rupture from sudden shock of the valves being closed.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What are the hazards of low pressure gas leaks?

A
  • Even though lighter than air if it built up in confined compartments such as hidden air pockets it can reach flammable/explosive mixtures.
  • In high concentrations can become an asphyxiant but only likely in confined spaces or in very close proximity to a very large gas release.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Is the smell of ethyl mercaptan confirmation of a gas leak?

A

No only potential. It is heavier than air whereas gas is lighter so may have dispersed. In addition, maintenance work on national grid infrastructure may mean deliberately vented.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What is the only true way of confirming the presence of natural gas?

A

DIM (Detection, Identification and Monitoring) equipment.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What are the hazards of ethyl mercaptan when stored in high levels such as at distribution centres?

A
  • Explosive range of 2.8-18.2%.
  • Extremely harmful to the environment and not be allowed to enter water course or drains.
  • Colourless to yellow liquid but may be dyed.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What is CO?

A

Carbon Monoxide. A by product of burning of natural gas and other fuels. Very toxic in small doses.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

How does CO’s density compare with air?

A

Same density so will mix in the room and adjoining rooms have potential to be contaminated.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

Information on natural gas risks on the ground should be gathered from?

A
  • 72ds.
  • local knowledge.
  • ORD.
  • On site specialist/responsible person.
  • Chemdata.
  • Other specialist advice.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

How do you quote wind directions? Is quoting wind direction always crucial?

A

Where the wind is coming from.
Eg ‘the wind is coming from the north’
Don’t place to much emphasis on wind direction in heavily built up areas as tall buildings create turbulence and unpredictable patterns.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What time or weather conditions will effect risk?

A

If no wind there may be limited or no dispersion above COMAH sites. Could be localised gas/vapour clouds.
This will be worse at night or during foggy days when vertical dispersion could be less effective.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Where should an initial appliance be sited for a low pressure gas leak?

A

Min 25m away unless incident or Pre-planning dictate otherwise. Not in line of site or front or rear of building. Greater than 45 degrees from front or rear.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

How can you immediately tell a high pressure gas pipeline has been ruptured?

A

The loud jet like noise.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
17
Q

Hazard zone for a high pressure rupture?

A

200m.

18
Q

What is minimum PPE for crews working within the hazard zone on a high pressure rupture?

A

Full PPE and BA.

19
Q

What is suggested hazard zone for congested conditions?

A

600m but consider 1000m/advice of HMEPO.

20
Q

What must the IC do for a ruptured high pressure main?

A

Request national grid to shit down supply via control. However, be aware that it may take a while.

21
Q

What should crews not do at a ruptured high pressure main?

A
  • Extinguish Any Fire where leak has ignited (surrounding risks may be protected if not putting crews at any undue risk).
  • attempt to Control Any leak.
22
Q

Hazard zone when a controlled leak from mass storage site?

A

1000m and await advice from HMEPO.

23
Q

Hazard zone for low pressure and domestic network?

A

25m and advice of GA.

24
Q

Can crews be committed to a building with a gas leak?

A

Yes if not at risk of gas explosion and wearing Full PPE and BA. Only when risk to life or critical infrastructure. Safety of gas supply rests with GA.

25
Q

Considerations prior to entering a building suspected of having a natural gas leak?

A
  • Isolate electrical supply externally.
  • Shutting off gas externally.
  • Ventilating property prior to entry.
  • PPE and BA.
  • Use of DIM.
  • Intrinsically Safe kit.
  • BARIE no hand held radio.
26
Q

What should crews do when a gas leak has ignited?

A

Not extinguish flames, evacuate area and lash jets in place to protect surroundings.

27
Q

Does LFB have power of entry at gas leaks to secure gas supply?

A

No. GA do. Crews should not make entry on behalf of GA unless exceptional public safety issue.

28
Q

Following any fire what may be a consideration if the IC related to the gas supply?

A

Radiated heat and high temp may affect gas apparatus and integrity causing a leak. If any reason to suspect this is the case the gas authority must be requested.

29
Q

Can you commit BA for a CO leak?

A

Yes. If persons involved then rescue number one priority.

30
Q

Is CO leak level 1 or 2 hazmat?

A

Calls to Domestic CO detector is level 1 and GA mobilised simultaneously. Suspected large leak or persons reported trapped is minimum level 2 attendance.

31
Q

What considerations should be BA crew have when committed to a CO leak?

A
  • CO when heated is lighter than air and will accumulate at highest point. As it cools it will dissipate and can potentially enter all rooms not just room of origin so all must be ventilated.
  • Turn off natural gas supply to all appliances.
  • Possible flammable atmosphere.
32
Q

Is BA always necessary at a suspected CO leak?

A

Yes as small doses of CO can accumulate over time and crews can become ill if exposed to small doses repeatedly.

33
Q

Whose detection equipment should an IC rely on if crews are committed to a risk area? GA, LFB or any other agencies?

A

LFBs DIM equipment.

34
Q

When deciding upon evac or shelter in place what does an IC need to consider?

A
  • shutting windows and doors.
  • HVAC systems shut down.
  • extinguishing naked flames.
35
Q

If evac needs to take place what must an IC take into account?

A
  • weather and wind direction.
  • hazard zone.
  • if premises of significant risk eg hospitals then RA needed. Risk/benefit.
36
Q

If a person refuses to leave the premises then what should the course of action be?

A

Pass details to the police.

37
Q

Who should a natural gas/CO leak be handed over to?

A

GA.

38
Q

If crews isolate gas supply or it has been shut off prior to arrival of brigade then what needs to be done?

A

A tag form 5288 should be attached to valve and GA informed via control that duty is handed over to them.

39
Q

Are crews ever left in place to provide cover for GA?

A

Not usually. LFB there for public safety however if a request is made then this needs to be authorised by the duty DAC and may be a chargeable special service.

40
Q

What terminology should not be used when sending messages relating to gas or electric?

A

Fittings or service. These have specific meanings within the industries. LFB should refer to gas or electrical apparatus if involved.

41
Q

When Control have to notify a GA that gas apparatus is involved what info needs to be included?

A
  • whether incident is inside or outside premises.
  • size of the fire.
  • Any injuries to MOP.