Landing Gear Flashcards
Wheel brake temperatures are displayed: A. As a status message B. On the hydraulic synoptic. C. On the gear synoptic. D. On the EICAS below the gear indicator
C. On the gear synoptic.
During takeoff, RTO braking will not occur unless groundspeed is above: A. 85 knots. B. 75 knots. C. 80 knots. D. 100 knots.
A. 85 knots.
During landing, auto brake application begins:
A. When both thrust levers are retarded to idle.
B. When spoilers deploy.
C. With wheel spinup.
D. A and C.
D. A and C.
Select a TRUE statement about alternate gear extension.
A. The landing gear free falls to the down and locked position.
B. Nose landing gear extends when land gear lever is positioned down.
C. Landing gear cannot be retracted after alternate extension.
D. The landing gear lever must be in the down position.
A. The landing gear free falls to the down and locked position.
The 787 has main gear steering.
A. True.
B. False.
B. False.
How do you know that the parking brake is set?
A. Normal and alternate brake pressures are available.
B. The EICAS memo message PARKING BRAKE SET is displayed.
C. The parking brake lever is in the up position.
D. The brake pressure gage is in the green band.
B. The EICAS memo message PARKING BRAKE SET is displayed.
Which autobrake mode provides the highest deceleration rate for landing? A. AUTOBRAKE 3. B. AUTOBRAKE 4. C. RTO. D. MAX AUTOBRAKE
D. MAX AUTOBRAKE.
How is the landing gear held in the up and locked position:
A. Solenoid actuated “gear clips.”
B. Electric motor driven locking cams.
C. Hydraulically actuated mechanical locks
D. Hydraulic pressure
C. Hydraulically actuated mechanical locks
Which of the following is true regarding gear down and locked sequence:
A. Hydraulic pressure unlocks the uplocks, gear falls by gravity, hydraulic pressure closes the gear doors.
B. Mechanical linkage unlocks the uplocks, gear falls with hydraulic assist, gear doors close via mechanical linkage.
C. Electric motor unlocks the uplocks, gear falls by gravity, hydraulic pressure closes the gear doors.
D. Hydraulic pressure unlocks doors, unlocks the uplocks, lowers the gear, and closes the gear doors
A. Hydraulic pressure unlocks the uplocks, gear falls by gravity, hydraulic pressure closes the gear doors
10) The landing gear speed limits for all configurations and modes are . A. 280 / 80 B. 270 / .82 C. 290 / .84 D. 285 / .85
B. 270 / .82
Hydraulic power for gear retraction and extension is supplied by the: A. Reserve hydraulic system. B. Right hydraulic system. C. Left hydraulic system. D. Center hydraulic system.
D. Center hydraulic system.
If an RTO is initiated below 85 knots groundspeed, the RTO autobrake function: A. Does not operate. B. Operates in the minimum function. C. Operates in the MAX AUTO rate. D. Operates in the maximum function.
A. Does not operate.
Which of the following will disarm the autobrake system and cause the EICAS “AUTOBRAKE” advisory message to display?
A. Selection of the Autobrake switch to Disarm.
B. Loss of IRSs.
C. RTO is initiated above 85 knots, but autobraking has not been applied.
D. All of the above.
D. All of the above.
The autobrake system disarms if: A. Pedal braking is applied. B. Either thrust lever is advanced. C. An antiskid system failure occurs. D. All of the above.
D. All of the above.
What does the alternate landing gear extension system use to extend the gear?
A. A dedicated DC hydraulic pump and trapped center hydraulic system fluid.
B. A reserve hydraulic booster to open the doors.
C. A pneumatically powered pump to open the gear doors.
D. C1 hydraulic pump pressure
A. A dedicated DC hydraulic pump and trapped center hydraulic system fluid.