Jeppesen Airframe Ch. 9 Sec. B Flashcards
1
Q
1 Metallic brake linings are also known as ____ linings.
A
sintered
2
Q
- Power brakes are operated using pressure from the ____ hydraulic system.
A
main
3
Q
- The hydraulic pressure to the brake system is reduced using (an) ____ system.
A
Deboosting (presurereducing)
4
Q
- A(n) ____ valve is designed to prevent a complete loss of hydraulic system fluid if a brake line fails or leaks.
A
Lockout debooster
5
Q
- In case of total failure of the hydraulic system, most large aircraft brake systems can be operated using a(n) _____ emergency system.
A
Pneumatic
6
Q
- The amount the automatic adjuster pin protrudes from the cylinder head of a Goodyear single-disk brake may be used as an indicator of the wear on the _____ _____.
A
Linings
7
Q
- Cleveland brake linings should be replaced when they have worn to a thickness of ____inch.
A
0.1
8
Q
8 _____ _____ brake action is nearly always an indication of air in the brake hydraulics system.
A
Spongy
9
Q
- The operation performed to remove air from the brake system is known as _____ the brakes.
A
Bleeding
10
Q
- When bleeding air from a master cylinder brake system using the pressure method, the fresh fluid is întroduced at the _____
A
Wheel cylinder
11
Q
- If a brake system is inadvertently serviced with the wrong type of hydraulic fluid what must be accomplished?
A
Drain and flush the system
Replace all the seals
12
Q
- Stopping a leaking MS-type flareless fitting by tightening the fitting _____ a proper repair procedure.
A
Is not
13
Q
- During brake overhaul the housings should be checked using the _____ _____ inspection method.
A
Fluorescent penetrant
14
Q
- It _____ necessary to remove the wheel to replace the linings on a Cleveland single-disk brake.
A
Is not
15
Q
- Anytime a brake shows signs of _____, it must be removed from the aircraft, inspected and rebuilt.
A
overheating
