JB_deck_4762656

Question 1

you make the decision as IT adm too switch too ASIC technology an employee ask why you made the switch from the old technology . what is a benefit of running ASIC ? p.161

Answer 1

runs up too gigabit speed with very low latency rates

Question 2

the employee then ask what the latency rate is(definition) ? p.161

Answer 2

latency is the time measured from when a frame enters a port to when it exits

Question 3

a repeater receives a digital signal, re amplifies or regenerates that signal, and then forward the digital signal out all active ports without looking at any data. so a hub is basically a multiple-port repeater T or F p.162

Answer 3

T

Question 4

your IT director ask you what you can use to enlarge the area covered by a single LAN segment. what can you use ? p.163

Answer 4

hubs and repeaters

Question 5

why would your IT adm request that you turned down the heat in a room or lab ? p.163

Answer 5

switches ,routers,hubs,and so on require proper environmental conditions to operate correctly

Question 6

does each computer have its own collision domain in figure 5.29 p.161

Answer 6

yes

Question 7

my destination is on a different segment, the frame can be transmitted only to that segment. what am i ? p.162

Answer 7

transparent bridging