IOS - CDP Commands

Question 1

Which Cisco IOS command is used to configure the amount of time the receiving Cisco device should hold the Cisco Device Protocol (CDP) packet from a neighboring router?

Answer 1

The cdp holdtime global configuration command.

Question 2

Which Cisco IOS command is used to configure the frequency at which the Cisco software sends CDP updates?

Answer 2

the cdp timer global configuration command

Question 3

Which Cisco IOS command is used to enable CDP on an interface?

Answer 3

the cdp enable interface configuration command

Question 4

What is the term for a special type of sygnal that enables routers to send and receive data at the correct rate?

Answer 4

clock rate

Question 5

Which Cisco IOS show command can be used to verify whether CDP is enabled on a particular interface?

Answer 5

the show running-configuration command

Question 6

Which Cisco IOS command is used to display information about a specific neighboring device discovered using CDP?

Answer 6

the

show cdp entry {* | device-name [*] [protocol | version]}

privileged EXEC mode command

Question 7

Define a static route to a network as a static default route.

Answer 7

ip default-network