GKPT4 Flashcards
You must park on the side of a level, straight, four lane ,divided highway. Where should you place.your three reflective triangles
10 feet, 100 feet, and 200 feet to the rear of the vehicle.
A stale green light means?
The light has been green for quite a while.
A vehicle is loaded with most of the weight on the steering axle. What may result.
Hard steering and possible breakdown.
When approaching a curve , you should:
Downshift before entering the curve and accelerate slightly as you go through it.
Should the pre-trip inspection report from the last driver be reviewed during your pre-trip inspection.
Yes
The load means the following?
The maximum safe weight a tire can carry at a specified pressure.
On average, the total stopping distance with air brakes is?
Approximately 450 feet.
To correct a rear wheel or drive wheel braking skid ,you should?
Release the brakes and counter steer.
Which of the following is not something you should check during a trip?
Text messages.
What is not part of the basic method for shifting up?
Accelerating while pressing the clutch and turning toward the driver side.
You should put the starter switch key into your pocket while you perform the pre-trip inspection because.
Someone could start and move the truck.
What is the best way to figure out how many seconds of following distance you have?
Wait until the vehicle ahead of your passes a shadow or landmark. Then count the seconds until you reach it.
Signs of distracted drivers include
Drivers having conversations with passengers.
The most important hand signal that you and a helper should agree on is ?
Stop.
If you have been drinking alcohol, before you drive, you should?
Wait for it to wear off.
Blocking the cargo to keep it from shifting must be done.
At the front , back , and/or sides of a piece of cargo.
Every time you park your vehicle and shut the engine off , you should.
Apply the parking brake.
If you are being tailgated, you should
Increase your following distance.
How long does it take a typical tractor-trailer to clear a single railroad track? A double railroad track?
It takes 14 seconds to clear a single track and more than 15 seconds to clear a double track.