Foam Pro

Question 1

The Foam Pro system is a ___ side, direct inject electronic foam system.

Answer 1

discharge

Question 2

The operation of the system is based solely upon ___.

Answer 2

water flow

Question 3

The system is capable of proportioning foam between ___.

Answer 3

0.1% to 3.0%.

Question 4

0.2%

Answer 4

1300 GPM

Question 5

0.5%

Answer 5

520 GPM

Question 6

1.0%

Answer 6

260 GPM

Question 7

3.0%

Answer 7

85 GPM

Question 8

The maximum operating pressure of the Foam Pro Model 2001 Foam System is ___ psi.

Answer 8

400

Question 9

▲ and ▼ buttons

If either button is held down for a period of ___ seconds, the value will increase or decrease accordingly.

Answer 9

2

Question 10

If the tank is empty, the pump will not run for more than ___ minutes.

Answer 10

2

Question 11

If two consecutive minutes of low concentrate level is detected, the display will show “___”, the pump will stop, and the system will go to Stand By mode until the foam level is restored and the on button is depressed.

Answer 11

No Con

Question 12

Motor stall protection is provided. In the event that the pump motor will not run or stalls for ____, the display will show “ERR.EL” to indicate that the pump is producing no feedback to the control signal.

Answer 12

10 seconds

Question 13

Press the FOAM button (red upper-left button). The on status lamp will ___, indicating that the system is in Stand-By Mode and the pump will stop.

Answer 13

extinguish

Question 14

When the fire pump is running, the foam pump cannot pump air efficiently against ____ psi backpressure.

Answer 14

100 to 150