Flows Flashcards
1
Q
Preliminary Pre-Flight (17)
A
- IRS Mode Selectors - OFF, then NAV
- Voice Recorder Switch - ON
- Verify
-Oxygen Pressure
- Hydraulic Quantity
-Engine Oil Quantity
Check the maintenance documents and aircraft logbook. - Flight Deck Access System Switch - GUARD CLOSED
- Emergency Equipment - CHECK
- ELT Switch - GUARD CLOSED
- PSEU Light - EXTINGUISHED
- GPS Light - EXTINGUISHED
- Service Interphone - OFF
- Engine Panel - SET
- Oxygen Panel - Set
- Landing Gear Indicator Lights - ILLUMINATED
- Flight Recorder Switch - GUARD CLOSED
- Mach Airspeed Warning Test Switches - PUSH TO TEST
- Stall Warning Test Switches - PUSH TO TEST
- Check the following:
- Circuit Breakers - none popped
- Manual Gear Extension Door Closed - Parking Brake - SET
2
Q
Before Start (8)
A
- CDU Display - Set
- N1 Bugs - Check
- IAS Bugs - Set
- Exterior Doors - Closed
- Windows - Closed/Locked
- Fuel Pumps - Set
- Hydraulic Pumps - Set
- Bypass Pin = A&B ON
- No Pin - B ONLY - Anti Collision Light - ON
If at night WING INSP. light ON too.
3
Q
Pushback or Towing Procedure (2)
A
- Transponder Mode Select - SET
- Select ALT ON/XPNDR
- Select ATC 1 or 2
When pushback complete, tow-bar disconnected, and nose gear steering lockout pin is removed:
- System A HYD Pumps - ON
- Low Press. Lights extinguished
- System A pressure minimum of 2800 psi
4
Q
Engine Start Procedure (4)
A
- Select Secondary Engine Indications
- PACK Switches - OFF
- Engine Start Switch - GRND
- Monitor Engine Start
Prior to starter cutout -
Monitor fuel flow & EGT
After Starter Cutout -
Call “Starter cutout”
Monitor N1 ,N2, EGT, FF, & Oil pressure
At 56% N2 if engine start switch doesn’t return automatically to AUTO/OFF move it to AUTO/OFF
Start Valve Open alert extinguishes
5
Q
Before Taxi (13)
A
- Generator Switches - ON
- Probe Heat - ON
- Engine/Wing Anti-Ice - AS NEEDED
- PACK Switches - AUTO
- Isolation Valve - AUTO
- APU Bleed - OFF
- APU Switch - AS NEEDED
- Allow 1 minute with bleed off prior to APU shut down - Missing
- Ground Equipment - CLEAR
- Flaps - SET
- set flaps after captain cals “flaps ____” - Lower DU - BLANK
- Transponder - ALT ON/XPNDR
- Recall - CHECK
6
Q
Before Takeoff (3)
A
- Weather/Terrain - AS NEEDED
- Exterior Lights - ON
All but landing lights on before cleared T/O
All lights on including landing when cleared - Transponder - TA/RA
7
Q
After Takeoff (5)
A
- Engine Bleeds - OPERATING
- PACKS - OPERATING
- Engine Start Switches - AUTO/OFF
- Autobrake - OFF
- Landing Gear Lever - OFF
- After landing gear retraction is complete.
8
Q
Descent (8)
A
- RNP - Verify
- Center Tank Fuel Pumps - SET
- See FCOM - Pressurization - Verify Set to Destination
- Recall - REVIEW
- Vref on APP Ref Page - ENTER
- RADIO/BARO minimums - SET
- Radios/Courses - SET FOR APPROACH
- Check the landing performance and set auto-brake to the desired setting.
9
Q
After Landing (8)
A
- APU - START (AS NEEDED)
- Probe Heat - AUTO/OFF
- Exterior Lights - SET
- Engine Start Switches - AUTO/OFF
- Autobrake - OFF
- Flap Lever - UP
- Transponder - ALT ON/XPNDR
- Weather Radar - OFF
10
Q
Shutdown (16)
A
- Electrical Power - SET
- Fasten Belts - OFF
- Anti-Collision - OFF
- Fuel Pumps - OFF
- CAB/UTIL Power Switch - OFF
- Wing/Engine Anti-Ice - OFF
- Hydraulic Panel - SET
- PACKS - SET
- Isolation Valve Switch - OPEN.
- Engine Bleed Witches - ON
- APU Bleed Switch - ON
- Exterior Light Switches - AS NEEDED
- Flight Director Switches - OFF
- Transponder Mode Selector - STBY
- APU Switch - AS NEEDED
- Run the APU for one minute with no bleed air load before shutdown - Flight deck Door - UNLOCK
11
Q
Secure (4)
A
- IRS Mode Selectors - OFF
- Emergency Exit Light Switch - OFF
- Window Heat Switches - OFF
- PACK Switches - OFF
