Fire Flashcards
What unlocks an engine fire switch?
Fire warning; or
Fuel control switch in Cutoff
FCOM 8.10.1
How many engine fire extinguishers are provided?
2 per wing
FCOM 8.20.4
What occurs when an engine fire switch is pulled out?
Arms the squib in each bottle
FCOM 8.20.4
How many APU fire bottles are provided?
1
FCOM 8.20.4
Can you shut down APU from outside the airplane?
yes, from the ground control fire protection panel
FCOM 8.10.9
What action discharges the fire extinguisher, for an engine/APU?
Rotating the fire handle
FCOM 8.20.4
Describe the fire protection system for the forward and aft lower cargo compartments
4 bottles for FWD & AFT LL’s
Pushing discharge switch punches two bottles immediately, the other two discharge after a brief delay or upon touchdown.
FCOM 8.20.5
State the acton that occurs when you push a FWD or AFT cargo fire arm switch
Configures cooling to closed loop
turns off two packs and airflow to all cargo compartments.
FCOM 8.20.7
What type of compartment is the main deck cargo compartment?
E
FCOM 8.20.7
What happens when you push the Cargo Fire Depressurisation Switch with the Main Deck Cargo Fire Arm Switch armed?
Opens the outflow valves to initiate a controlled cabin depressurisation.
FCOM 8.20.7
What happens when you push the Main Deck Cargo Fire Arm Switch?
FWD: Arms cargo fire extinguishers Configures equipment cooling to override (airflow off) Turns off pack 3 and all fans Turns off NGS
AFT:
same, but also turns off Aft Cargo Heat
FCOM 8.10.4
Describe the engine/fire overheat detection system
Dual loop fire detector in each nacelle.
Dual loop overheat detector in each nacelle.
Both loops required to activate unless configured for single loop ops.
FCOM 8.20.2
Describe the APU Fire/Overheat detection system
Dual loop fire detector, no overheat detector.
FCOM 8.20.2
Describe the Cargo Compartment Fire Detection System
Lower cargo has 4 dual loop detectors
Main deck has 16 dual dual loop detectors that draw smoke with bleed air.
FCOM 8.20.3
What happens if a fault occurs in one loop upon completion of any fire and overhead fault test?
FIRE TEST FAIL?
FCOM 8.20.9