ERJ Flows

Question 1

ORIGINATING

Answer 1

AIRWORTHINESS ACCEPTANCE- complete

DISPLAY CONTROLLER UNIT (DCU)-
Baro set, HSI= compass or arc, BRG on or off

GLARESHIELD LIGHT CONTROL-
As required

ADSP HEATERS-
On if OAT greater/less than 0^C and water/ice/snow present or below -18^C on FFOD

REVERSIONARY PANEL-
Auto, pushed out and dark

PFD-
No flags

AUDIO PANEL-
Mic: auto, spkr on, vol set, spkr off

O2 and INTERPHONE-
Yellow blink & spkr on

ALTERNATE GEAR EXTENSION COMPARTMENT-
Alt gear ext lever full down, electric override switch normal

Question 2

BEFORE START

Answer 2

Tasks:

MCDU::
ACARS-
Initialized

FMS-
if PF, route & perf init up to ZFW

GUIDANCE PANEL-
course, altitude, source, heading (CASH)

T/O BRIEFING-
if FO is PF, WANT; EFB setup (route, taxi chart, dep chart)

Then:
CREW O2-
Verify mask glow & check quantity (MFD status page)

PFD-
Check indications (FMA clear w no flags)

MFD-
Check or set appropriate selections

Question 3

TAKEOFF PERFORMANCE

Answer 3

1) MCDU- determine ZFW and speeds
2) set STAB trim

CA Enter data::
PERF INIT 2/3— enter ZFW
PERF INIT 2/3— enter T/O CG
PERF INIT 2/3— chk correct fuel load
PERF INIT 3/3— verify climb, cruise, descent speeds
T/O DATASET MENU— enter T/O thrust/config
TAKEOFF 1/2— chk correct rwy preloaded
TAKEOFF 2/2— select flap setting
TAKEOFF— enter T/O speeds
TO/GA— press TO/GA buttons after setting Vfs

Question 4

BEFORE START

“below the line”

Answer 4

SEAT BELT/SHOULDER HARNESS-
On

BEACON-
On

HYDRAULIC PUMP 3A-
On

DOORS/WINDOWS-
Closed and locked

TRANSPONDER-
On, select TA/RA

Question 5

AFTER START

Answer 5

MFD- select STATUS page