Engine Operation (Idle) Flashcards
Engine Motoring must be performed for which ICAW?
GEN HOT 1&2 ICAW
Engine must not be operated for which ICAW’s?
FUEL HOT / FUEL CRITICAL
If ICAW does not go away when engine gets to idle, engine operation must be stopped to troubleshoot which ICAW?
GEN OIL FAIL 1&2
If ETR higher then Idle is required, engine must be operated for minimum of ____ before advancing throttle.
2 MIN
FUEL CRITICAL ICAW is set at ____. Judgement of personal and task being performed will dictate minimum quantity of fuel on ACFT before start.
1000lbs
IPP must be operated for minimum of ____ before engine start.
1 MIN
Fuel Feed tank temperature must be more than ____ prior to engine start.
-18°C
Oil pressure can decrease into ____ range for approximately ____ during start sequence, and then rebound into the ____ range.
RED / 3 SEC / GREEN
Oil pressure should increase with increasing ____ RPM and when above ____ PSI, oil pressure gauge will turn green and ____ gauge will turn yellow.
N2 / 15 / ETR
Engine start is not permitted if tailwinds is more then ____.
30 Knots
If engine motoring was performed, engine N2 must be ____ before engine operation can be performed.
0% RPM
Engine ____ RPM must always be ____ prior to switching engine states.
N2 / 0%
If ambient temperature is less than ____, 2 minute motoring must be accomplished.
0°F
If engine start is less than ____ of abnormal engine shutdown or less than ____, but greater than ____ from normal shutdown, ____ engine motoring must be performed prior to engine start that follow.
6 HRS / 6 HRS / 20 MIN / 2 MIN
Engine Start will ____ if ____ RPM does not get to ____% within ____ or ____% within ____.
AUTO ABORT / N2 / 20-22 / 45 SEC / 55 / 150 SEC
