ECAM SWITCHING PANEL

Question 1

If the UPPER DISPLAY knob was switched to OFF what would occur?

Answer 1

The E/WD display would automatically transfer to the lower display

Question 2

With the E/WD displayed on the lower screen, how else can you view SD information?

Answer 2

Press and hold the appropriate system button on the ECAM CONTROL panel you wish to view

Question 3

How long will this information be available?

Answer 3

30 seconds

Question 4

What does the ALL pb do?

Answer 4

• Displays ALL the system pages successively in 1-second intervals when held down
• Release the pb to maintain display of the selected page

Question 5

What does pressing the RCL pb?

Answer 5

• Allows you to recall any warning or caution messages that the activation of the CLR pb or flight phase inhibition
may have suppressed
• If held longer than 3 seconds, the E/WD will show any caution messages suppressed by the EMER CANC pb

Question 6

If power fails to the ECAM CONTROL panel which buttons are still functional?

Answer 6

• EMER CANC
• ALL
• CLR
• STS
• RCL

Question 7

What does the EMER CANC do?

Answer 7

• Cancels the current Level 1 or 2 cautions for the remainder of the flight
• Cancels the current Level 3 aural warning and Master Warning light for that occurrence,
but does not affect the ECAM message display

Question 8

What do you look for on the FHED check?

Answer 8

• Fuel – fuel quantity, configuration, and balance
• Hyd – hydraulic quantity
• Eng – oil quantity above 12.5 quarts
• Door – doors closed, slides armed, crew oxygen pressure

Question 9

What occurs when the T.O. CONFIG pb is pressed?

Answer 9

• The system simulates the application of T.O. power and checks certain systems for proper configuration
• A warning is displayed if a system is not configured properly
• “TO CONFIG NORMAL” is displayed in the TO MEMO section if the configuration is correct