DTP Flashcards

1
Q

When running “show int trunk”, what does the output “n-“ designate?

A

The encapsulation type (ISL or 802.1q) was auto-negotiated.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What are the two DTP modes?

A

Auto and desirable.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

How do you turn off DTP?

A

Switchport mode trunk, switchport nonegotiate

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Briefly describe DTP.

A

Dynamic trunking protocol. Attempts to form trunks by sending a DTP frames out desirable ports.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

Is DTP industry standard?

A

No, it is Cisco proprietary.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

How often are DTP frames sent?

A

Every 30 seconds.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

DTP is a security risk because it allows the introduction of ___ into your network.

A

Rouge switches.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What is a good command to use to check a trunk’s DTP status?

A

Show interface switchport. Look for the “Negotiation of Trunking” field. Use the pipe modifier.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What is a good command to use to check a trunk’s DTP status?

A

Show interface switchport. Look for the “Negotiation of Trunking” field.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

If a switch supports ISL and 802.1q, what must you do before you can disable DTP?

A

Disable protocol negotiation, hard-code 802.1q protocol at the interface level.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly