Dash 1 - Engines

Question 1

Max thrust

Answer 1

40,440

Question 2

How many stages in low pressure compressor

Answer 2

4

Question 3

How many stages in high pressure compressor

Answer 3

12

Question 4

How many stages in the low pressure turbine section

Answer 4

5

Question 5

How many stages in the high pressure turbine section

Answer 5

2

Question 6

How many injectors in combustion section

Answer 6

24

Question 7

N1(low spd rotor) has 1 fan, _ low press compressor stages and __ low press turbine stages

Answer 7

4 and 5

Question 8

N2(high spd rotor) has __ high press compressor stages and __ high press turbine stages

Answer 8

12 and 2

Question 9

ENGINE OIL PRESS X appears on the WAP when the pressure is below

Answer 9

70 PSI

Question 10

What is the reccomended supply pressure for APU air start

Answer 10

20 psig

Question 11

What is the reccomended supply pressure for crossbleed start

Answer 11

25 psig

Question 12

What is the reccomended supply pressure for external air start

Answer 12

30 psig

Question 13

For cold weather starts below __ use A&B engine ignition switch position

Answer 13

32 Deg F

Question 14

For starting with tailwind exceeding __kts, place throttles in idle reverse

Answer 14

25

Question 15

If a continuous PACK DSAG light is on during start, turn off pack prior to reaching

Answer 15

20% N2 - Do not turn off after 20% or starter damage will result

Question 16

A possible hot or hung start may occur if fuel is switched on at less than

Answer 16

18% N2 RPM

Question 17

Motor engine until EGT is below __ if it has been recently run

Answer 17

190 deg C

Question 18

At ___ turn the ENG SHUT OFF switch to the on position

Answer 18

18% N2

Question 19

If no EGT rise is noted after ___, turn off engine switch and motor for __, then stop start

Answer 19

20 sec/30 sec

Question 20

Fuel flow should be approx

Answer 20

400-500 PPH

Question 21

If EGT rises rapidly and approaches ___, stop start

Answer 21

495 deg C

Question 22

N1 will not have any indication prior to

Answer 22

40%

Question 23

The engine start switch pops out at

Answer 23

51% N2 RPM

Question 24

If the engine start switch fails to pop out, manually pull it out by

Answer 24

55% N2 RPM

Question 25

Sea level engine start should not exceed __ seconds using APU or engine crossbleed start

Answer 25

120 - May be exceeded if engine is still excellarating

Question 26

Normal N1 indications at idle are

Answer 26

24 +/- 3

Question 27

Normal N2 indications at idle are

Answer 27

60% +/- 5

Question 28

EGT at idle shuld be less than___ with no bleed

Answer 28

460 deg C

Question 29

EGT at idle should be less than ___ with bleen on

Answer 29

490 deg C

Question 30

Fuel flow at idle should be

Answer 30

900-1000 pph

Question 31

Oil press min at idle

Answer 31

70 psi

Question 32

Select engine anti-ice if temp is below

Answer 32

42 deg F

Question 33

Before takeoff, warm up engine until oil temp is at or above

Answer 33

50 deg C

Question 34

The starter allows __ consecutive attempts followed by a __ min cooling period

Answer 34

2 attempts/15 min

Question 35

The starter requires each start be followed by a __ min cooling period

Answer 35

10

Question 36

The starter requires no more than __ start attempts in 1 hour

Answer 36

5

Question 37

The engine may be motored up to a max of __ min

Answer 37

15

Question 38

For motoring greater that 90 sec up to 15 min, a cooling period of __ for each __ is required

Answer 38

5 mins for each 30 sec - (up to 40 min total)

Question 39

Shortly after placing the engine shutoff switch to on, you should notice fuel flow of

Answer 39

400-500 pph

Question 40

Stop the start if the fuel flow exceeds __ at initial EGT rise

Answer 40

700 pph

Question 41

Stop the start if the EGT rises rapidly and approaches

Answer 41

495 deg C

Question 42

A minimum oil pressure of __ PSI is needed during engine start

Answer 42

70

Question 43

if after __ min, the low oil press annunciation is still on, shut down the engine

Answer 43

2

Question 44

If you discharge a fire bottle, time for how may seconds before discharging second

Answer 44

30

Question 45

For a precautionary engine shutdown, conditions permitting, allow engine to cool at idle for

Answer 45

3 min

Question 46

For engine fail/driftdown, after setting INT, confirm cruise airspeed-no lower than

Answer 46

250 kts/10% N2 RPM

Question 47

The THRUST LOSS annunciator indicates one engine EPR is __ below the average

Answer 47

0.15

Question 48

How many smoke detectors are there

Answer 48

22

Question 49

How many smoke detectors in the cargo compartment

Answer 49

14