Connecting Network Devices Flashcards
Which of the following connectors is typically used on one end of a rollover cable?
LC F type BNC ST Serial SC
Serial
You want to create a rollover cable that has an RJ-45 connector on both ends. How should you connect the wires within the connectors?
– Use the T568A standard on one and and a T568B standard on the other end
– Connect with 1 pin with pin 3 and pin to 2 pin 6
– Connect pin 1 to 8, pin 2 to pin 7, pin 3 to pin 6, and pin 4 to pin 5
–Connect each pin on one end to the same pin on the other end
– Connect pin 1 to 8, pin 2 to pin 7, pin 3 to pin 6, and pin 4 to pin 5
You need to connect a workstation to a switch using a regular port on the switch not an up link port. This which does not support auto MDI.
Which type of cable should use?
Rollover
Crossover
Loopback
Straight through
Straight through
You want to connect the LAN port on the router to the uplink port on a switch. The switch does not support auto MDI.
Which type of cable should you use?
Rollover
Crossover
Loopback
Straight through
Crossover
You have purchased a new router that you need to configure. You need to connect a workstation to the routers console port to complete the configuration tasks.
Which type of cable would you most likely use?
Crossover
Rollover
RG-6
Straight through
Rollover
You have two switches that you need to connect using their uplink ports. The switches do not support auto MDI.
Which type of cable should you use?
Loop back
Straight through
Rollover
Crossover
Crossover
Which of the following standards is typically used in a rollover cable?
RG-58
RS-232
RJ-11
RG-6
RS-232
You need to transfer data from one laptop to another and would like to use an ethernet cable. You do not have a hub or a switch.
Which type of cable should you use?
Rolled over
Straight through
Look back
Crossover
Crossover
