Chpater 95- Hot Water& Steam Heating Boiler Operation Flashcards
Before starting up a new boiler or one that has been out of service the following must be ensured
The boiler has a valid inspection certificate
It is very important that boilers should be warmed
Warmed up slowly to prevent thermal shock
During the warmup period of a heating boiler, the main burner goes out. The operator should
Shut down the boiler, close the fuel valve, and determine the cause of the problems
Thermal shock can be reduced by
Warming up boilers slowly Keeping the boilers free of scale build up Covering the tube sheets with refractory Not allowing full flow of cold water into a warm hot water boiler
Before staring a new hot water boiler or after a prolonged shutdown, the first item that should be checked is
The inspection certificate
During the cold startup of a boiler, slight smoking may occur in__________ fired furnaces
Oil
In hot water boiler operation the maximum operating temperature should never exceed
121 degrees Celsius
The operating pressure of a hot water heating boiler should be
25% below the relief valve setting
A gradual increase of stack temperatures is an indication of
Unclean heating surfaces
If shot water heating system is slightly low on water and the boiler is in the lowest part of the system, then the
Upper floors will begin to lose heat
At what pressure should a hot water heating boiler operate if the relief valve is set to 200 Kpa
131 Kpa
At what pressure should a hot water heating boiler operate is the relief valve is set to 750 Kpa
562 Kpa
How often would you test the low level fuel cut off on a low pressure steam heating boiler by blowing out the float chamber
Daily
According to the Alberta safety codes act in a low pressure steam boiler, the pressure must be no higher than
103 Kpa
The most important rule in safe operation of a steam heating boiler is
Keep the water level in the boiler at the proper level