Chemotherapy Dosing and Monitoring (Tom Gray) Flashcards
What is the most widely used method of calculating chemotherapy dosing?
Body surface area (BSA)
An individual calculation based on height and weight og each patient.
What formulas are used to calculate BSA?
Dubois and Dubois
SA = (W0.424 x H0.725 x 71.88) / 10,000 (numbers for W and H to the power).
Where does the Dubois and Dubois formula come from?
Wrapped 9 cadavers in bandages and paste to determine surface area.
What is their a correlation between with BSA?
Correlation with BSA and renal function.
What is ideal BSA?
A healthy ideal BSA for that body type
What is actual BSA?
The calculated/ measured BSA.
Is the ideal or actual BSA used when treating/managing patients?
Actual
What is the problem with capping BSA?
Obese patients may be undertreated if BSA is capped.
What else is considered when managing a dose, alongside BSA?
The treatment intent; in curative treatment the dose may be increased because greater side effects are tolerated in the event of cure, this increase also reduces the chances of relapse also.
What are the disadvantages to BSA?
BSA is estimated using the Dubois and Dubois numbers.
The effect of renal disease or impairment could be overlooked.
BSA formulae does not consider obesity or cachexia (low body weight as a result of course of the cancer.
There is no precise correlation between dosing and clearance rate.
No direct relationship is shown with BSA and outcome.
Rounding of the BSA calculation and dose usually occurs to give a convenient and measurable dose.
When is BSA used?
In clinical trials, Phase I and II continued use.
Used as a starting point for dosing and then adjusted after the first cycle of chemo according to toxicity and response.
What are some of the causes of variation in doses received by patients?
Individual patient drug handling; pharmacogenetics, disease effects, renal/hepatic dysfunction, co-morbities.
Vial contents; manufacture variation, vial type, vial sharing.
Weight height BSA; Shoes, clothes, time of day
Syringe accuracy; manufacturer, type, size, use i.e air bubbles etc
Residual volumes during administration; filter, adsorption, practice, flushing of the line.
When is Area Under the Curve used in dosing?
AUC used to dose carboplatin (which is renally excreted).
How is AUC calculated?
The Calvert equation is used to calculate the dose based on creatinine clearance;
Dose (mg) = target AUC (mg/ml x min) x [GFR ml/min + 25]
GFR comes from Cockroft Gault equation.
When using the Calvert equation what must be considered? (Part of the equation when calculating AUC)
The GFR is important and must be accurate
Is the CG equation enough, should calculated GFR be used or should it be measured?
Is it based on actual, ideal or adjusted body weight?
How is the GFR calculated (in general and also for the Calvert equation)?
Use ideal body weight (can be an estimate H-100 for men, H-105 for women). CrCl is 46ml/min.
Using adjusted body weight is 53ml/min. Lots of variation.
In reality, never use an estimated GFR
How can GFR be determined without guessing?
Radiolabelled EDTA or DPTA is best practice
Which group of drugs are normally dosed based on weight?
Biologicals e.g. bevacizumab, trastuzumab, pertuzumab
Generally doses are not capped.
Easier to calculate, use a recent, accurate weight.