Checks And Scans Flashcards
Pre Start Checks - Capt
Oxy Handle - Pull ON
Oxy Mask - Test / 100%
ELT - Arm
Circuit Breakers - In
Fuel System - Check
Park Brake - Set
SFDS - Test / ON
Engine Anti Ice - ON
Avionics Master - OFF
Overhead Panel - Check
Dimmers & Lights - As Req’d
Voltages - Check
Fuel System Check - Capt
Batt - ON
Firewall Shutoff Valves - CLOSED
Battery - OFF
Crossfeed - Check
Boost Pumps - ON
Firewall Shutoff Valves - OPEN
Boost Pumps - OFF
Transfer Pumps - Test
Pre Start Voltage Check
Battery - Min 23 V
Triple Feed - Min 22 V
R & L Gen - 0 V
Centre - Min 23 V
Pre Start Scan - Capt
Annunciators - Test
NAV Lights - ON
LDG Gear Control handle - DOWN
LDG Gear Lights - Test
Gear Annunciator - 3 Green
Hydraulic Fluid Sensor - Test
All other Switches - As Req’d
Reversionary Panel - Check
Cockpit Vioce Recorder - Test
Power Levers - IDLE
Prop Levers - FULL FWD
Condition Levers - CUT-OFF
Emergency LDG Gear Ext - Stowed
Cabin Pressure Switch - Test / PX
Rudder Boost - ON
Pre Start Scan - FO
Oxy Mask - Test / 100%
Circuit Breakers Panel - Check
Pitot Static Air Source - NORMAL
Co Pilot Audio - Check
Oxy Pressure - Check - (MIN 1000 Psi)
Cabin Temp Mode - OFF
Vent Blower - AUTO
No Smking / Seatbelt - ON
All Other Switches - OFF
Pedestal Cover - OPEN
Pre Pre Start - PF
MR Brief
ATIS
Performance
Departure Briefings
Airways / Start Clearance (AS Req’d)
Engine Start Checklist
ABOVE - AND - BELOW
Oxygen - Tested 100%
Fuel System - Checked
Engine Anit Ice - ON
Park Brake - SET
Prop Levers - FULL FWD
Condition Levers -* CUT OFF*
Voltages - Checked
Cabin Temp Mode - OFF (FO)
Briefings - Complete (Both)
THE LINE
Boost Pumps - ON
GEN Ties (Manual) - CLOSE
Engine Start Checklist Complete
Before Start Flows -
Boost Pumps - ON (Capt)
GEN Ties (manual) - CLOSE (Capt)
Beacon - ON (Capt)
Na Lights - OFF (Capt)
Engine Start
Left /Right - Starter Engage
N1 = 12.5 % - Condition Low Idle (fuel)
ITT
OIL
N1 51 % - Starter OFF
Start Flows - Both
Engine Start -
GENs (Props out of FX) - RESET / ON
Transfer Pumps - AUTO
Crossfeed - AUTO
Electrical System - Check
Avionics MAST - ON
SFDS - Initialised
Cabin Temp Mode - AUTO (FO)
Bleed Air VAlves - OPEN (FO)
FLT & Engine Instruments / FMS Pos - Check / Set (Both)
TCAS Terrain - Test / STBY
Start Electrical System Checks
Prior To Avionics MAST ON
GEN Ties - OPEN ( Check ANN Panel-L&R GEN Tie)
TRLP Feed - 26.5-28 V
R&L GEN - 27.5-29 V (<1V Diff)
CTR - 23 V Min (Batt ONLY)
Leave on CTR
GEN Ties - Normal (Check ANN panel)
BUS Sense Switch - Momentary TEST - L&R GEN Tie + BAT Tie ANN ON)
CTR Bus - 0V
BUS Sense Switch - Momentary RESET - L&R GEN Tie + BAT Tie ANN OFF)
CTR Bus - 27.5-29 V
GEN Loads =/- 10%
After Start Checklist
Transfer Pumps - AUTO (Capt)
Crossfeed - AUTO (Capt)
Elec System - Checked (Capt)
SFDS - Initialised (Capt)
FLT & Engine Instruments / FMS Pos - Check / Set (FO)
FLT & Instrument / FMS Checks
- PFD - Both Sides - NO Red XX’s
- Set QNH x3 - Altimeter Check
- DATA Base Check
- Use GPS Pos on next Pg - paste into P.POS/Origin’
5.TBC
TCAS / TAWSChecks
- OP Mode Switch - OFF (REV Panel)
- Press & Hold TFC (1 sec) - Test
TAWS+ - Ensure All TAWS+ switches(above BARO)/ANNUN are De-Selected
- Ensure That Terrain is BLUE, No INOP Messages
- P.Pos Map Dispayed on MFD
- Press G/S INHB (unmarked button above BARO, top left)
- POS INI must be completed first
- Leave Radar BLUE
TAXI Flows
Radio - Req / Taxi Call (Capt)
EXT Lights - As req’d (Capt)
CLR L&R - (Both)
Park Brake - Release (Capt)
Brakes Check - (Both)
Turning Checks - Instrument (Both)
Before T/Off Checks - Capt
Boost Pump / Auto / XFeed - Test
Elect Pitch Trim - Check (1st FLT)
Trim Tabs - SET
Governor / Rudder Boost - Check (1st FLT)
NEU / VAC - Check (1st FLT)
Auto Feather - Check (1st FLT)
Pressurisation - Check / SET
Autopilots & Yaw Damper - Check
Ice Protection - AS Req’d
Autofeather - ARMED
Manual Feather - Check (@Low Idle)
Before T/Off Checks - FO
Radios / Avionics / Radar / FMS - SET
V Speeds - SET
FLT / ENG Instr - Set / Check
AP / FGP - Modes Selected
Flaps - Approach SET
FLT Controls - Check
Hatches & Harnesses - Checked (Visual & ANN Panel)
Before T/Off Checklist
Boost Pump / Auto / XFeed - Tested (Capt)
Trim Tabs - Checked & SET (Both)
Governor / Rudder Boost - Checked (Capt)
Auto Feather - Checked / ARMED (Capt)
Prop Feathering - Checked (Capt)
Pressurisation - Checked / SET (Both)
Autopilots & Yaw Damper - Checked - Mode Selected (Both)
Radios / Avionics / Radar / FMS - Checked & SET (Both)
T/Off Speeds - SET (Both)
FLT / ENG Instr - Checked & Set (Both)
Flaps - SET (Both)
FLT Controls - Checked (Both)
Hatches & Harnesses - Checked (Both)
Before T/Off Checklist Complete
Holding Point (approaching)
Checks & Line Up Checklist
Engine Anit-Ice - AS Req’d (Capt)
Bleed Air Valves - OPEN (FO)
Transponder - 1 (Odd Days)/ 2 (Even Days)
Line Up Checklist Complete
Line Up Flows
Engine AUTO IGN - ARM (Capt)
Strobes & Recog Light - ON (Capt)
Ice Protection - As req’d (Capt)
Anunciators - Check (All Green)
TRIM Checks
- Pilot & Co-Pilots Trim Switches
- Move individual rock switch FWD/Back - NO Trim wheel Movement
- Move dual Rocker Switches FWD/BACK - Check for TRIM wheel Movement
- Check Capt’s Trim select overrides Co-Pilots Trim
- AP/Trim Disconnect - Press & Hold 2nd Level - RED TRIM on PFD
- Release AP/trim disconnect - Red TRIM on PFD OFF
- Trim TABS - RESET
Governer / Rudder Boost / Pneumatic / Vac System Checks
- Rudder Boost Control Switch - Rudder Boost
- Prop Levers - IGH RPM
- Prop GOV Test Switch - HOLD To TEST - (throughout the entire exercise)
- LEFT PWR Lever - 1700 RPM (1670-1800)
- LEFT Prop Lever - Retard to indent (RVS Not Ready) - then back full FWD (RVS OFF)
- VAC & Pneumatic PX Gauges - Green ARC Throughout
- Left PWR - advance until rudder movement noted (*Be aware of ITT and Torque limits)
- REPEAT RIGHT ENGINE
- Prop GOV Test Switch - Release
Auto Feather Checks
- Auto Feather Switch - HOLD To TEST
- PWR Levers - 500’/lbs Torque
- L&R AFX illuminate on PFD / L Auto Fx & R Auto Fx illuminate ANN Panel
- PWR Levers - Retard individually - @400’/lbs Opposite ANN extinguish - @260’/lbs Autofeather activates
- Return PWR Lever to 500’/lbs
- repeat Opposite engine
- Both Power levers - Both retard - Both AFX and ANN Auto feather Extinguish
- Autofeather Switch - Release
Pressurisation System Check
- Bleed Air Valves - OPEN
- Cabin ALT Selector Knob - Adjust (1000’ below Field PA)
- Rate CTRL Selector Knob - 12 O’clock
- Cabin Px Switch - Hold in TEST
- 10-20 sec delay
- Cabin Clim Indicator - Check for RoD indication
- Cabin Px Switch - Release to PX Position
- Set Cabin ALT to CRZ ALT + 1000’
- Power - IDLE ??
- Rate Knob - Hard Left (around 10ish)