CCNA NAT SIM Question 2

Question 1

Question

You work as a network technician at 9tut.com. Study the exhibit carefully. You are required to perform configurations to enable Internet access. The Router ISP has given you six public IP addresses in the 198.18.32.65 198.18.32.70/29 range.
9tut.com has 62 clients that needs to have simultaneous internet access. These local hosts use private IP addresses in the 192.168.6.65 – 192.168.6.126/26 range.
You need to configure Router1 using the PC1 console.
You have already made basic router configuration. You have also configured the appropriate NAT interfaces; NAT inside and NAT outside respectively.
Now you are required to finish the configuration of Router1.

Answer 1

Solution

Note: If you are not sure how NAT & PAT work, please read my Network Address Translation NAT Tutorial. You can download a similar sim to practice here: http://www.9tut.com/download/9tut.com_CCNA_NAT_sim_question.zip

The company has 62 hosts that need to access the internet simultaneously but we just have 6 public IP addresses from 198.18.32.65 to 198.18.32.70/29 => we have to use NAT overload (or PAT)

Double click on PC1 to access Router1′s command line interface

Router1>enable
Router1#configure terminal

Create a NAT pool of global addresses to be allocated with their netmask (notice that /29 = 248)

Router1(config)#ip nat pool mypool 198.18.32.65 198.18.32.70 netmask 255.255.255.248

Create a standard access control list that permits the addresses that are to be translated

Router1(config)#access-list 1 permit 192.168.6.64 0.0.0.63

Establish dynamic source translation, specifying the access list that was defined in the prior step

Router1(config)#ip nat inside source list 1 pool mypool overload

This command translates all source addresses that pass access list 1, which means a source address from 192.168.6.65 to 192.168.6.126, into an address from the pool named mypool (the pool contains addresses from 198.18.32.65 to 198.18.32.70)

Overload keyword allows to map multiple IP addresses to a single registered IP address (many-to-one) by using different ports

The question said that appropriate interfaces have been configured for NAT inside and NAT outside statements.

This is how to configure the NAT inside and NAT outside, just for your understanding:

Router1(config)#interface fa0/0
Router1(config-if)#ip nat inside

Router1(config-if)#exit

Router1(config)#interface s0/0
Router1(config-if)#ip nat outside

Before leaving Router1, you should save the configuration:

Router1(config)#end (or Router1(config-if)#end)
Router1#copy running-config startup-config

Check your configuration by going to PC2 and type:

C:\>ping 192.0.2.114

The ping should work well and you will be replied from 192.0.2.114