5.7 - Troubleshooting Networks Flashcards

1
Q

No network connectivity

A
  • Do you have a link light?
    – Is it plugged in?
  • Ping loopback (127.0.0.1)
    – Is the protocol stack working?
    – Availability and intermittent connectivity
  • Ping local IP address
    – Checks local configuration, adapter, and link signal
  • Ping default gateway
    – Connectivity on the local network
  • Ping devices on router’s other side
    – 8.8.8.8 or 9.9.9.9
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Intermittent wireless connectivity

A
  • Interference
    – Something else is using our frequency
  • Signal strength
    – Transmitting signal, transmitting antenna,
    receiving antenna, etc.
  • Incorrect channel
    – Usually automatic; look for manual tuning
  • Bounce and latency
    – Multipath interference; flat surfaces
  • Incorrect access point placement
    – Locate close to the users
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Wireless interference

A
  • Predictable
    – Fluorescent lights
    – Microwave ovens
    – Cordless telephones
    – High-power sources
  • Unpredictable
    – Multi-tenant building
  • Measurements
    – Signal to noise ratio (SNR)
    – Performance Monitor
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Signal to noise ratio (SNR)

A
  • Signal
    – What you want
  • Noise
    – What you don’t want
    – Interference from other networks and devices
  • You want a very large ratio
    – The same amount of signal to noise (1:1)
    would be bad
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

Limited or no connectivity

A
  • Windows alert in the system tray
    – “Limited or No connectivity”
    – “No Internet Access”
  • Check the local IP address
    – An APIPA address will only have local connectivity
  • If DHCP address is obtained,perform the ping tests
    – Local gateway, remote IP address
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Jitter

A
  • Most real-time media is sensitive to delay
    – Data should arrive at regular intervals
    – Voice communication, live video
  • If you miss a packet, there’s no retransmission
    – There’s no time to “rewind” your phone call
  • Jitter is the time between frames
    – Excessive jitter can cause you to miss information,
    “choppy” voice calls
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Poor VoIP quality

A
  • High speed and low latency
    – Real-time applications are demanding
  • Check the Internet connection
    – A speed test can identify slow links
  • Verify the local networking equipment
    – An old router can cause significant problems
  • View the network performance
    – A packet capture would be useful
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

Latency

A
  • A delay between the request and the response
    – Waiting time
  • Some latency is expected and normal
    – Laws of physics apply
  • Examine the response times at every step along the way
    – This may require multiple measurement tools
  • Packet captures can provide detailed analysis
    – Microsecond granularity
    – Get captures from both sides
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Port flapping

A
  • Network interface goes up and down
    – Over and over again
  • Verify the cable
    – Check the wiring
  • Move between switch interfaces
    – Is the flapping associated with the switch
    interface or the device?
  • Replace bad hardware or cables
    – May require additional purchases
How well did you know this?
1
Not at all
2
3
4
5
Perfectly