316

Question 1

The process of giving a drilled hole a fine finish with a single-point tool is

Answer 1

Boring

Question 2

A countersink cuts tapered enlargements at hole openings to accommodate

Answer 2

Screw heads

Question 3

The two dimensions that describe lathe capacity are the center distance and the

Answer 3

Swing

Question 4

To break a long chip in a tapping operation, you should

Answer 4

Reverse the tap half a turn

Question 5

What type of reamer is held on an arbor in a machine?

Answer 5

Shell

Question 6

An ideal tap for most tapping operations is the _____ tap

Answer 6

Spiral-point or gun

Question 7

By what means can you hold a workpiece for turning, facing, drilling, and boring?

Answer 7

Hold it in a chuck

Question 8

The metal between the flutes of a reamer is called the

Answer 8

Land

Question 9

Which of the following materials requires the highest drilling speed in sfpm?

Answer 9

Wood

Question 10

What is the suggested speed for finish cutting mild steel?

Answer 10

125 sfpm

Question 11

The purpose of a steady rest or center rest is to support the

Answer 11

End of a long workpiece

Question 12

The smoothness of a finishing operation depends on the ______ and on the ______

Answer 12

Tool sharpness……. feed rate

Question 13

The device that moves with a cutting tool to keep long workpieces straight is the _____ rest

Answer 13

Follower

Question 14

To change the speed in surface feet per minute to inches per minute, you must

Answer 14

Multiply it by 12

Question 15

to enlarge a hole to fit an oversize bearing, you should use a

Answer 15

Boring tool

Question 16

You can mount eccentric or irregularly shaped workpieces in a chuck or

Answer 16

On a faceplate

Question 17

When you need a very accurate hole, what is the best method to use?

Answer 17

Hand reaming

Question 18

The most common form of precision threads for moderate power transmission needs is the _____ thread

Answer 18

Acme

Question 19

Cold forming or fluteless taps are used to tap what kind of material?

Answer 19

Ductile

Question 20

In a dry seal, the tiny tunnel between the pipe and fitting is filled with

Answer 20

Flattened metal

Question 21

When you turn a workpiece in a lathe, the carriage must be connected to the

Answer 21

Feed rod

Question 22

The inside surface of what type of chuck is shaped to fit the stock it holds?

Answer 22

Collet

Question 23

The principle parts of a twist drill are the body, shank, and

Answer 23

Point

Question 24

You can remove burrs on the cutting edges or teeth of reamers with a(n)

Answer 24

Oilstone

Question 25

On a vertical lathe or boring machine, the _____ advances the boring tool into the work.

Answer 25

Overhead ram