2nd Discussions Flashcards
Located/ installed outboard of the win trailing edge. Its movement is always opposite.
Aileron
Produces lift during takeoff, and stability during landing maneuvers.
Flaps
Provides directional control along the yaw axis or vertical axis.
Rudder
Provides directional control along the lateral or pitch axis
Elevator
Up-Down
X-axis (vertical/yaw)
Nose-Tail
Y-axis longitudinal (roll)
Left-Right wingtip
Z-axis lateral (pitch)
Largest structural component of the aircraft which provides housing for passengers and cargo. It is also where other structural components are attached.
Fuselage
2nd largest component of the airplane’s function is to provide lift
Wing
Sections of the fuselage (3)
Nose/fore
Mid/Middle
Aft/Rear
Empennage
Also known as the tail assembly of the aircraft comprising the vertical and horizontal stabilizer; It is where the rudder and elevator are attached.
Landing Gear
Serves as an undercarriage/ chassis of the aircraft which supports it during landing role, take-off role, and when the aircraft is on the ground (including taxi-ing)
Power Plant
Provides thrust force needed on the aircraft
Two types of propeller
Pusher
Puller
A propeller type that is MOUNTED on the REAR of the aircraft
Pusher
A propeller type that is MOUNTED on the NOSE of the aircraft
Puller
Types of Landing gear (2)
Fixed Landing Gear
Retractable Landing Gear
It is an executive/VIP light transport aircraft, designed by Piaggio Aero and built in Italy. It is also seen in the movie “Salt”
Piaggio P180 Avanti
SWD- a device to warn the pilot of a stall
Stall Warning Device
Continuous loss of speed
Stall
GPWS- It warns the aircraft if it is too close to the ground
Ground Proximity Warning System
A combination of Rudder and Elevator FCS
Ruddervator
A combination of Flaps and Aileron FCS
Flaperon
____ refers to forces that oppose the relative motion of an object through the air.
Drag
Classifications of Drag (4)
Profile
Parasite
Induced
Interference
_____ drag is created as a result of lift.
Induced
______ Drag is drag that is generated by the mixing of airflow streamlines between airframe components such as the wing and the fuselage.
Interference
____ Drag is the drag caused by the separation of the boundary layer from a surface and the wake created by that separation.
Profile
_____ Drag is caused by moving a solid object through a fluid medium.
Parasite
FCS only seen on larger aircraft (5)
PLain
Split
Slot
Fowler
Forward
FCS stands for?
Flight Control System
It is the movement of the aircraft while on the ground
taxi-ing
Speed ranges
Subsonic
Transonic
Supersonic
Hypersonic