14.1.12 CPDLC Flashcards
- With the use of CPDLC/ADS-C, separation of aircraft will be?
(CPDLC Presentation)
• Laterally? 30nm
• Longitudinally? 30nm or 50nm, depending on the airspace.
- Is pilot action required to send ADS-C position reports?
(CPDLC Presentation)
• No pilot action is required.
- If ADS-C is not available from a particular ATSU, what is the positionreporting procedure using CPDLC?
(AOM Vol I, Ch SP)
• Report over all compulsory reporting points
• Send an ATC position report from the Position Report Page of the FMS.
- When must you accomplish an ADS/CPDLC Logon, if required, usingthe ATC LOGON/STATUS page?
(AOM Vol I, Ch SP)
• 10-25 minutes prior to entry into ADS CPDLC airspace
- What page would you go to verify if the Data Link is Ready?
(AOM Vol I, Ch SP)
• Either by selecting the FMC COMM button or selecting ATC, then LOGON/STATUS.
- Under what condition would you select ADS OFF?
(AOM Vol I, Ch SP)
• Unless ATC has requested you to select it off, it is Kalitta Air policy not to select ADS OFF.
- When reporting by ADS-C only, can flight crews remove non-compulsory ATC waypoints?
(CPDLC Presentation)
• Although physically possible, it is not permitted.
- What is the required response time for an ATC uplink? What do you do if you cannot respond in time?
(AOM Vol I, Ch SP)
• One minute.
• Send a STANDBY response.
- After receipt of a “Conditional Clearance” the PNF should?
(AOM Vol I, Ch SP)
• Leave the ATC UPLINK page displayed until the clearance has been complied with.
• Print the ATC UPLINK page and place the printout where both pilots can see it until the clearance has been complied with.
- While using CPDLC to communicate with ATC, the EICAS message “DATALINK LOST” appears. What do you do?
(AOM Vol I, Ch SP)
• Revert to voice communications.
• Attempt to re-establish data link IAW the ACARS Supplemental Procedures.
