Volume 1 Flashcards
The estimated % of accidents caused by nature is: A) 2 B) 4 C) 6 D) 8
A
What is the percentage of accidents attributable to unsafe acts and physical hazards? A) 50 B) 70 C) 90 D) 98
D
Which directives are used when performing maintenance procedures? A) Manuals, CDCs, and Handbooks B) TOs, Manuals, and CDCs C) Manuals, TOs, and Handbooks D) TOs, Handbooks, and CDCs
C
What safety training phase is described as an effective tool that creates a lasting impression for new airmen? A) Initial B) General C) Supervisors D) Sustained job safety
A
A chemical must be defined as a carcinogen in the MSDS if concentrations are greater than: A) -2% B) -1% C) 0.1% D) 1%
C
Hazardous Waste Management System rules are published by: A) USAF B) MAJCOM C) DoD D) EPA
D
Temporary storage of hazardous materials at a central accumulation point cannot exceed: A) 30 days B) 60 days C) 90 days D) 120 days
C
What affects radiation hazards?
A) Strength of emission, time of day, and input power
B) Strength of emission, time of exposure, and weather
C) Input power, weather, and # of personnel in area
D) Time of exposure, amount of training, and # of operating units
B
The recommended procedure for cooling an overheated brake aasy is to park the acft in an isolated location and then: A) Spray with cold water B) Cool with forced air from blower C)Cool with high pressure compressed air D) Allow the assy to cool in ambient air
D
Which symptom is NOT a sigh of noise fatigue? A) dizziness B) emotional irritability C) a feeling of emptiness D) impaired mental concentraton
C
The noise intensity of a jet engine is greatest toward the rear of the engin and to either side at an angle of: A) 15 B) 45 C) 65 D) 95
B
When launching an acft containing live ammunition, who is responsible for removing the safety devices associated with these explosive devices?
A) Crew chief
B) F/E
C) Weapons personnel
D) Only senior personnel on special orders
C
Before moving an explosives loaded acft into a hangar, you must:
A) Install shortening plugs and clips
B) Install mechanical safetying devices
C) Remove all ammunition and explosives
D) Position fire control switches to SAFE or OFF
C
All composite material related safety training must be documented on which AF IMT? A) 55 B) 457 C) 623 D) 1297
A
The first step in developing an effective FOD prevention program is to
A) ensure the tool control program in functioning properly
B) follow MAJCOM guidelines
C) identify all possible sources of FOD
D) educate all personnel
C
Who is responsible for FOD prevention? A) Logistics and Operating grp CC B) Immediate supervisor C) Wing CC D) Everyone
D
