VLAN 2

Question 1

Question 1
Which feature facilitate the tagging of a specific VLAN?
A. Routing 
B. Hairpinning 
C. Encapsulation 
D. Switching

Answer 1

Answer: C

Question 2

Question 2
What are three advantages of VLANs? (Choose three)
A. VLANs establish broadcast domains in switched networks.
B. VLANs utilize packet filtering to enhance network security.
C. VLANs provide a method of conserving IP addresses in large networks.
D. VLANs provide a low-latency internetworking alternative to routed networks.
E. VLANs allow access to network services based on department, not physical location.
F. VLANs can greatly simplify adding, moving, or changing hosts on the network.

Answer 2

Answer: A E F

Question 3

Question 3
Under normal operations, Cisco recommends that you configure switch ports on which VLAN?
A. on the default vlan 
B. on the management vlan 
C. on the native vlan 
D. on any vlan except the default vlan

Answer 3

Answer: D

Question 4

Question 4
Which two protocol can detect native vlan mismatch errors? (Choose two)
A. CDP 
B. VTP 
C. DTP 
D. STP 
E. PAGP

Answer 4

Answer: A D

Question 5

Question 5
Which statement about VLAN configuration is true?
A. The switch must be in VTP server or transparent mode before you can configure a VLAN
B. The switch must be in config-vlan mode before you configure an extended VLAN
C. Dynamic inter-VLAN routing is supported on VLAN2 through VLAN 4064
D. A switch in VTP transparent mode save the VLAN databases to the running configuration only

Answer 5

Answer: A

Question 6

Question 6
Which statement about vlan operation on Cisco Catalyst switches is true?
A. when a packet is received from an 802.1Q trunk, the vlan id can be determined from the source MAC address table.
B. unknown unicast frames are retransmitted only to the ports that belong to the same vlan.
C. ports between switches should be configured in access mode so that vlans can span across the ports.
D. broadcast and multicast frames are retransmitted to ports that are configured on different vlan.

Answer 6

Answer: B

Question 7

Question 7
Which two statements about data VLANs on access ports are true ? (Choose two)
A. They can be configured as trunk ports
B. Two or more VLANs can be configured on the interface
C. 802.1Q encapsulation must be configured on the interface
D. Exactly one VLAN can be configured on the interface.
E. They can be configured as host ports.

Answer 7

Answer: D E

Question 8

Question 8
Which feature facilitates the tagging of frames on a specific VLAN?
A. Routing 
B. Hairpinning 
C. Switching 
D. Encapsulation

Answer 8

Answer: D

Question 9

Question 9
Assuming the default switch configuration which vlan range can be added modified and removed on a Cisco switch?
A. 2 through 1001 
B. 1 through 1001 
C. 1 through 1002 
D. 2 through 1005

Answer 9

Answer: A