URE's Flashcards
The maximum load capacity of the MHU-141/M trailer is…?
5,500 pounds
Which meter is a four-wire Kelvin digital ohmmeter used for testing Aim-9 and the Aim-120 missile system?
AMTEC 620
When the MHU-141 trailer is loaded or towed with the hinged deck open, what must be done?
The 2 deck panel supports must be properly positioned and locked in place with quick release pins.
What is the maximum load capacity of the MHU-226 trailer?
12,000 pounds
Which wheel truck has a manually extendable lift arm?
MHU-83 series bomb-lift truck
Which lift truck has cantilever lift arms?
MJ-1 series aerial stores lift truck
When using the MHU-83B with fork adapters, you immediately …?
Reduce it’s lifting capability by 1,000 pounds
What is the drawback to using the hydraulic hand pump to build pressure on the MHU-83B/E?
Extremely slow way to build hydraulic pressure
Which AF form is used to document a daily inspection on a general cargo truck?
1800
What is the purpose behind good operator maintenance of all assigned vehicles?
Maintain vehicle serviceability at reduced cost
What range should be selected in a tractor with an automatic transmission while going down grades?
Low range
Which procedure is not a consideration for backing a tractor/trailer combination?
Turn toward the passengers’ side.
What is the maximum depth of water you may drive a rough-terrain forklift through?
5 feet
Which ammunition loading system services the M61A gun system?
Linkless ammunition loading system (LALS)
Which component is not one of the 5 weapons replaceable assemblies?
Ammunition drum.
Which technical order covers the linkless ammunition loading system (LALS)?
35D2-19-1.
Which weapons replaceable assembly receives ammunition from 3 bays of the container assembly and merges them into a single stream?
Transfer unit
Which weapons replaceable assembly consists of the flex drive assembly?
Conveyor.
Which component transfers rounds into the aircraft gun feed system?
Universal aircraft interface unit.
What is the weight capacity of the air driven hoist attached to each gantry of the A/E32K-3 munitions assembly conveyor (MAC)?
4,000 pounds
Why is it important to monitor net explosive weight (NEW) during a bomb build up operation?
If ignited, excessive NEW may cause propagation of an explosive from another location.
What does not apply to munitions and explosives in the transportation mode?
Quantity distance requirements.
When is it permissible to transport explosives in privately owned vehicles?
Never
Which publication provides information on the correct positioning of munitions and tie-down procedures?
TO 11-1-38