Untitled spreadsheet - Sheet1

Question 1

How do you fly a Hi Speed ILS?

Answer 1

85% power + 2600rpm = c165. At t FAF/GS: 65% @17” = c145; at 3.5nm go to idle. At 1nm you will be at 130kts, and can lower Flaps

Question 2

Is there a PFD failure - how do you check (and turn it off)?

Answer 2

Are the Bezel lights off? PULL C/Bs (No 4 in Cols 1 & 2)

Question 3

If the PFD fails - can you fly on AP?

Answer 3

Yes: fly NAV + NAV (HDG not available). For Heading/Vectors: use Cursor; select heading from present position; create +MAP, and Direct-to to that

Question 4

If the PFD fails - how do you handfly?

Answer 4

see GPS screens in notes. Use instruments. Consider timed turns (3 degrees per sec)

Question 5

GPS - how do you Intercept an airway or a FPLN leg?

Answer 5

Direct-to; Direct-to; Enter (to end point). [Compare with Direct-to; Enter, which goes to a waypoint]

Question 6

GPS - how do you activate a leg of FLPN?

Answer 6

Select end of leg; Direct-to; Direct-to; Enter

Question 7

GPS - how do you set up an extended centreline?

Answer 7

Press Direct-to; set Course (CRS) Field to XXX; then Enter, Enter

Question 8

GPS - how do you rubber band your route?

Answer 8

Nav p2, move cursor; then Direct-to. In FLPN, select waypoint after +MAP, and dial in +MAP

Question 9

GPS - how do you remove a waypoint from your FPLN?

Answer 9

highlight it & press CLR

Question 10

GPS - how do you go direct to the IAF?

Answer 10

Press PROC; select Activate Approach (and so skip all intermediate waypoints)

Question 11

GPS - how do you cancel an Approach?

Answer 11

Direct-to; Enter; Enter

Question 12

GPS - how do you cancel a Direct-to?

Answer 12

Direct-to; Menu; Enter

Question 13

GPS - on VTF how do you avoid deleting the FLPN waypoints?

Answer 13

Activate leg to the FA (Final Approach) by hi-lighting it; then MENU, Activate Leg.

Question 14

Vortex - how do you land?

Answer 14

Beyond/long

Question 15

Vortex - how do you take off?

Answer 15

Before/short

Question 16

How do you calculate the correct speed on a 3 degree glideslope?

Answer 16

Ground speed x 5 (eg 165kts = 825fpm; 100kts = 500fpm)

Question 17

What are the settings for Downwind?

Answer 17

0% flaps; 100kts (30%,15”)

Question 18

What are the settings for Abeam?

Answer 18

50% flap; 100kt (15%, 12”)

Question 19

What are the settings for Finals?

Answer 19

100% flaps; 80 kts

Question 20

What are the settings for when 1/2 below GS?

Answer 20

50% flaps; 100 kts (30%, 15”)

Question 21

What are the settings for after the FAF when descending on GS?

Answer 21

50% flap; 100 kts (15%, 12”)

Question 22

What are the settings for normal Climb?

Answer 22

2500-2600rpm, max %power, lean as per placard

Question 23

What are the settings for normal Cruise?

Answer 23

less than 75% power; Lean Assist to -25 to -50 degrees of LOP

Question 24

What are the settings for Slow Cruise (eg on Approach)?

Answer 24

45% power; mixture Rich

Question 25

What are the settings for normal 800-900 ft Descent?

Answer 25

Descend at cruise LOP%age; every 1000ft enrich mixture and power back

Question 26

What are the settings for slow Descent (eg Approach)?

Answer 26

25% power; mixture rich

Question 27

You can go Mixture Rich on a decent at what height?

Answer 27

5,000ft (and turn pump on)

Question 28

Summarise the Missed procedure?

Answer 28

Press OBS (but climb first if there is an obstacle!); then on GPS1: CDI=GPS (not VLOC); set Bug to MA ALT; set AP to NAV+NAV and ALT

Question 29

How do you insert a Hold in the FPLN?

Answer 29

press OBS; fly out with HDG; then Direct-to the beacon & set CRS degrees to beacon; then HDG+NAV+NAV

Question 30

How do you fly the Procedure Turn?

Answer 30

fly out using HDG; turn HDG; then activate inbound leg (select end, then Direct-to, Direct-to, then Enter) then HDG+NAV