TPC 319

Question 1

Before new equipment arrives at the plant for installing it are made by the

Answer 1

Plant engineer

Question 2

When pouring a concrete footing, you should hold the steel rods in position with

Answer 2

tie wires

Question 3

The best materials for filing around a foundation are gravel and

Answer 3

ground concrete slabs

Question 4

The type of bolt to anchor the equipment is usually specified by the

Answer 4

equipment manufacturer

Question 5

How long must new concrete sit before you can install equipment on it?

Answer 5

28 days

Question 6

Retainers on the sides of horizontally reciprocating equipment keep it from

Answer 6

walking

Question 7

To isolate anchor bolts when mounting equipment on pads, surround the bolts with

Answer 7

neoprene tubing

Question 8

What type of wrench should you use for tightening anchor bolts

Answer 8

Torque

Question 9

To drill anchor bolt holes larger than 1 1/2 in., you should use a

Answer 9

core bit with a diamond or carbon tip

Question 10

You should not use a concrete mix to grout anchor bolts, because the concrete

Answer 10

shrinks when it sets

Question 11

If new equipment is damaged in shipment you should report it to the

Answer 11

carrier

Question 12

What must you do first before disconnecting the electrical wiring to existing equipment?

Answer 12

Shut off the power

Question 13

What is the least number of rollers you should use under a load on a skid

Answer 13

Three

Question 14

When moving equipment with a crowbar, what should you use between the bar and the floor?

Answer 14

A wood block

Question 15

If you have no clearance to remove a sling after setting the equipment down, you should lower the equipment onto

Answer 15

wedges

Question 16

To keep your body heat from affecting a master precision level, you should handle it by its

Answer 16

non heat conductive top plate

Question 17

To support a level on an inverted V shaped way, use a precision

Answer 17

V block

Question 18

To support a level across machine tool ways in different planes, you should use precision ground parallels or

Answer 18

gauge blocks

Question 19

The common dial indicator is usually used with a ___ base.

Answer 19

Magnetic

Question 20

When an alignment screw is finally set you can prevent further movement by

Answer 20

applying a sealing compound

Question 21

The external air lines on equipment usually terminate just beyond a filter or a

Answer 21

regulator

Question 22

If the fluid in a system is thick you can control it with a ___ check valve

Answer 22

ball

Question 23

You can keep the fluid pressure in a line near a preset level with a ___ valve

Answer 23

regulating

Question 24

A copy of the manufacturers test data is often attached to the ___ of new equipment.

Answer 24

manual

Question 25

High temperatures during equipment start up is usually caused by

Answer 25

poor lubrication