Theory Flashcards
25m
According to RS 485 Standard, what is max length cable segment?
1200m
RS-422 - max segment cable length?
1200m
Best describes a synchronous serial communication system?
Uses a long string of bts to synchronize receiver before data is detected
How many masters/drivers on RS232 segment?
1
How many receivers/slaves on 4-wire RS 485 segment?
31
How many receivers/slaves on 2-wire RS 485 segment?
32
How many receivers/slaves on 4-wire RS 422 segment?
10
How many masters/drivers on 4-wire RS 422 segment?
1
How many nodes on 2-wire RS 485
32
Max cable length for RS232 19.2kBaud system utilizing copper conductor
25
How many masters/drivers on 4-wire RS 485 segment?
1
How many receiver/slaves on an RS 232 segment?
1
RS 232
unbalanced
RS 485
balanced
RS 422
balanced
transmission mode for RS 232
Full Duplex
transmission mode for 4-wire RS 485
Full Duplex
transmission mode for 4-wire RS 422
Full Duplex
transmission mode for 2-wire RS 485
Half Duplex
approximate resistance of End of The Line Resistor
100-120 Ohm
RS 232
Tx carries data from DTE to the corresponding pin on DCE
CTS is output from DCE
Rx carries data from DTE to the corresponding pin on DTE
RX is an output from DTE
Max Baud rate for RS 485
10 Mbps
most accurate description of a cable used to connect a DTE to DTE
Null-Modern cable
most accurate description of a cable used to connect a DTE to DCE
Straight through cable
RS 485 utilize a —– transmission system which requires —- per signal
balanced
2 conductors
RS serial communication standard use a —- voltage to define a logic 0 state and — Voltage to define 1 state for DATA LINES
+5
- 5
RS serial communication standard use a —- voltage to define a logic 0 state and — Voltage to define 1 state for CONTROL LINES
+25
-25
Matching DB9 connector NULL MODEM, DTE to DTE with hardware hand shaking
GND - GND
DCD - DCD
RTS - CTS
Rx - Tx
DTR - DSR
Tx - Rx
CTS - RTS
DSR - DTR
Matching DB9 PIN
Pin 1 - DCD - DATA CARRIER DETECT
PIN 2- Rx - RECEIVE
PIN 3- Tx - TRANSMIT
PIN 4 - DTR - DATA TERMINAL READY
PIN 5 - GND - GROUND
PIN 6 - DSR - DATA SET READY
PIN 7 - RTS - READY TO SEND
PIN 8 - CTS - CLEAR TO SEND
PIN 9 - RI - RING INDICATOR
Place holder for manually marked network diagram
Physical sheet
Baud Rate
The rate at which signal changes
communication mode that used for simultaneous bi-directional communication
Full Duplex
DCE
Data Communication Equipment
DTE
Data Terminal Equipment
Which factor affect transmission speed
error rate
band width
signal to noise ratio
data throughput
What was the 1st DCS manufacturer?
Yokohama Centum
which year?
1975
how many bits in a Nibble?
4
How many bits in an Octet?
8
How many bits in a Byte
8
How many bits in a word
32
how many bits in a single deterger?
8
Greater than 500 IP & OP device
DCS
Greater than 100 less than 500 IP & OP devices
PLC
Lees than 100 IP & OP
SCADA
Control Large & Local geographic areas
DCS
Responsible for data communications collection
MTU
Isolated skid automation
PLC
Control Far & Large geographic areas
SCADA
Regulatory control excellence
DCS
Discrete Control superiority
PLC
5 IEC-61131-3 programming languages
Instruction List, Function Block, Ladder Logic, Sequential Function Chart, Structure Text
6 largest current day DCS Manufacturer
Emerson, Rockwell, Yokohama, Honey Well, Schneider Electric, ABB
6 current day DCS respectives
Delta V, Plant Pax, 800xA, PCS 7, Eco Structure