test prep

Question 1

HOW FAR FROM THE BOTTOM AND SIDE OF WINDSHIELD ARE DECALS TO BE PLACED?

Answer 1

NO CLOSER THAN ONE INCH TO THE LEFT EDGE, APPROX FOUR INCHES FROM THE BOTTOM

Question 2

IF VEHICLE HAS OTHER LEGALLY REQUIRED DECAL IN CORNER OF WINDSHIELD, WHAT DO YOU DO?

Answer 2

PLACE DECAL 1/4 INCH TO THE RIGHT OF OTHER STICKER OR DECAL

Question 3

A MINIMUM OF TWO WHEELS, ONE FRONT AND ONE REAR, MUST BE INSPECTED ON EACH PASSENGER AND MULTIPURPOSE VEHICLE OF WHAT GROSS VEHICLE WEIGHT RATING?

Answer 3

10,000 LBS OR LESS

Question 4

PASSENGER VEHICLES MANUFACTURED AFTER WHICH DATE ARE NOT EQUIPPED WITH A RED BRAKE FAILURE WARNING LAMP OR WARNING LAMP DOES NOT LIGHT WITH PARKING BRAKE APPLIED WHEN IGNITION KEY IS TURNED TO THE START POSITION, EXCEPT FOR ANTI-LOCK SYSTEM?

Answer 4

JANUARY 1, 1968

Question 5

INSPECT AND REJECT IF: LESS THAN ___ RESERVE IN ACTUATOR TRAVEL OF THE SERVICE BRAKE WHEN FULLY APPLIED.

Answer 5

1/5

Question 6

INSPECT AND REJECT IF: RIVETED LININGS OR DISC PADS ARE WORN TO LESS THAN ____ OF AN INCH OVER THE ________.

Answer 6

2/32

RIVET HEADS

Question 7

INSPECT AND REJECT IF: BONDED OR MOLDED LININGS OR DISC PADS ARE WORN TO LESS THAN ____ OF AN INCH IN OVERALL THICKNESS.

Answer 7

2/32

Question 8

AFTER WHAT MANUFACTURE DATE ARE TRAILERS WITH A GROSS WEIGHT OF 3,000 LBS OR MORE REQUIRED TO BE EQUIPPED WITH EMERGENCY BREAKAWAY BRAKES?

Answer 8

JANUARY 1, 1964

Question 9

INSPECT AND REJECT IF: ANY MODIFICATION HAS BEEN MADE THAT AFFECTS NORMAL FUNCTIONING OF THE ________.

Answer 9

SHOCK ABSORBERS

Question 10

__________ SHALL NOT BE USED AS U-BOLTS IN THE SUSPENSION SYSTEM.

Answer 10

ALL THREAD ROD MATERIAL

Question 11

INSPECT AND REJECT IF: THE FRONT SUSPENSION HAS BEEN MODIFIED BY THE USE OF ________: ANY SOLID PIECE OF WOOD, METAL, OR OTHER MATERIAL PLACED BETWEEN AND SEPARATING THE ________.

Answer 11

LIFT BLOCKS

FRONT AXLE AND SPRINGS

Question 12

INSPECT AND REJECT IF: RACK AND PINION STEERING ________ ARE DEFECTIVE OR MISSING.

Answer 12

BELLOWS/BOOTS

Question 13

INSPECT AND REJECT IF: BULBS ARE NOT OF AN APPROVED TYPE AND MARKED WITH THE FOLLOWING: ________, ________, ________.

Answer 13

LIGHT SOURCE TYPE
MANUFACTURER’S NAME OR TRADEMARK
DOT

Question 14

ANY VEHICLE OTHER THAN MOTORCYCLES MANUFACTURED, ASSEMBLED, OR RECONSTRUCTED AFTER WHICH DATE MUST BE EQUIPPED WITH A WINDSHIELD?

Answer 14

JULY 1, 1970

Question 15

INSPECT AND REJECT IF: ANY MOTOR VEHICLE MANUFACTURED OR ASSEMBLED AFTER ________, OR ANY BUS, TAXICAB, OR SCHOOL BUS MANUFACTURED OR ASSEMBLED AFTER _______, IS NOT EQUIPPED THROUGHOUT WITH SAFETY GLASS, OR OTHER SAFETY GLAZING.

Answer 15

JANUARY 1, 1936

JANUARY 1, 1935

Question 16

INSPECT AND REJECT IF: WINDSHIELD HAS ANY CLOUDINESS ___ INCH(ES) ABOVE FROM THE BOTTOM, ___ INCH(ES) INWARD FROM THE OUTER BORDERS, ___ INCH(ES) DOWN FROM THE TOP, OR ___ INCH(ES) INWARD FROM CENTER STRIP.

Answer 16

3
1
1
1

Question 17

INSPECT AND REJECT IF: ANY HOOD SCOOP INSTALLED ON ANY MOTOR VEHICLE MANUFACTURED FOR THE YEAR ____ OR EARLIER MODEL YEAR CANNOT EXCEED ____ INCHES HIGH AT ITS HIGHEST POINT MEASURED FROM THE JUNCTION OF THE DASHBOARD AND WINDSHIELD.

Answer 17

1990

2-1/4

Question 18

INSPECT AND REJECT IF: ANY HOOD SCOOP INSTALLED ON ANY MOTOR VEHICLE MANUFACTURED FOR THE YEAR ____ OR SUBSEQUENT MODEL YEAR CANNOT EXCEED ____ INCHES HIGH AT ITS HIGHEST POINT MEASURED FROM THE JUNCTION OF THE DASHBOARD AND WINDSHIELD.

Answer 18

1991

1-1/8

Question 19

ANY VEHICLE DISPLAYING AN EXPIRED STICKER OR DECAL ON ITS WINDSHIELD AT THE TIME OF INSPECTION, EXCLUDING A ________, SHALL NOT BE ISSUED AN APPROVAL STICKER UNLESS THE ________ AUTHORIZES ITS REMOVAL.

Answer 19

REJECTION STICKER

OWNER OR OPERATOR

Question 20

INSPECT AND REJECT IF: THERE IS A PIT, CHIP, OR STAR CRACK LARGER THAN ___ INCH(ES) IN DIAMETER AT ANY LOCATION IN THE WINDSHIELD ______ THE ___-INCH LINE AT THE ______.

Answer 20

1-1/2
ABOVE
3
BOTTOM

Question 21

INSPECT AND REJECT IF: SUNSHADING MATERIAL, WORDS, LETTERING, NUMBERS, OR PICTURES ON THE WINDSHIELD THAT EXTEND BELOW ______ OR ___ INCH(ES) DOWNWARD FROM THE TOP OF THE WINDSHIELD.

Answer 21

THE AS-1 LINE

3

Question 22

INSPECT AND REJECT IF: AT ANY LOCATION IN THE WINDSHIELD ABOVE THE ___-INCH LINE AT THE BOTTOM THERE IS MORE THAN ONE CRACK FROM THE SAME POINT IF AT LEAST ONE OF THE CRACKS IS MORE THAN ___ INCH(ES) IN LENGTH

Answer 22

3

1-1/2

Question 23

INSPECT AND REJECT IF: REAR WINDOW IS CLOUDED OR DISTORTED SO THAT THE DRIVER DOES NOT HAVE A VIEW OF ___ FEET TO THE REAR.

Answer 23

200

Question 24

COLORED OR TINTED VISORS THAT DO NOT EXCEED MORE THAN ___ INCH(ES) FROM THE FORWARD DOOR POST INTO THE DRIVER’S VIEWING AREA ARE PERMITTED

Answer 24

2

Question 25

INSPECT AND REJECT IF: FRONT SIDE WINDOWS HAVE CLOUDINESS ABOVE ___ INCH(ES) FROM THE BOTTOM OF THE GLASS.

Answer 25

3

Question 26

INSPECT AND REJECT IF: GLASS IN THE LEFT FRONT DOOR CANNOT BE ______ SO THAT A HAND SIGNAL CAN BE GIVEN.

Answer 26

LOWERED

Question 27

INSPECT AND REJECT IF: WINDSHIELD GLASS, ON THE ______ SIDE, HAS ANY SCRATCH MORE THAN ___ INCH(ES) WIDTH AND ___ INCH(ES) LONG WITHIN THE AREA COVERED BY THE ________, EXCLUDING ___ INCH(ES) FROM THE ______.

Answer 27

``` DRIVER'S 1/4 6 WIPER BLADES 3 BOTTOM ```

Question 28

INSPECT AND REJECT IF: VEHICLE NOT EQUIPPED WITH HORN IN GOOD WORKING ORDER, CAPABLE OF EMITTING A SOUND AUDIBLE OVER A DISTANCE OF NOT LESS THAN ___ FEET.

Answer 28

200

Question 29

INSPECT AND REJECT IF: ANY ___ AND SUBSEQUENT MODEL VEHICLE IS NOT EQUIPPED WITH SAFETY LAP BELTS FOR AT LEAST TWO FRONT SEATS OR A COMBINATION OF LAP BELTS AND SHOULDER STRAPS.

Answer 29

1963

Question 30

INSPECT AND REJECT IF: ANY PASSENGER CAR MANUFACTURED ON OR AFTER ________ IS NOT EQUIPPED WITH LAP/SHOULDER OR HARNESS SEAT BELT ASSEMBLIES LOCATED AT THE FRONT OUTBOARD DESIGNATED SEATING POSITIONS (EXCEPT IN CONVERTIBLES) AND LAP SEAT BELT ASSEMBLIES IN ALL OTHER SEATING LOCATIONS

Answer 30

JANUARY 1, 1968

Question 31

INSPECT AND REJECT IF: ANY CONVERTIBLE PASSENGER CAR MANUFACTURED ON OR AFTER ________ DOES NOT HAVE A LAP SEAT BELT ASSEMBLY FOR EACH DESIGNATED SEATING POSITION.

Answer 31

JANUARY 1, 1968

Question 32

NO MOTOR VEHICLE MANUFACTURED FOR THE MODEL YEAR ___ OR FOR ______ MODEL YEARS SHALL BE OPERATED UNLESS IT IS EQUIPPED WITH AN AIR POLLUTION CONTROL SYSTEM DEVICE, OR COMBINATION OF SUCH SYSTEMS OR DEVICES INSTALLED IN ACCORDANCE WITH FEDERAL LAWS AND REGULATIONS.

Answer 32

1973 | SUBSEQUENT

Question 33

INSPECT AND REJECT IF: MOTORCYCLE BRAKE LEVERS (FOOT AND HAND) DO NOT HAVE AT LEAST ___ OF THEIR TRAVEL AS RESERVED AFTER BRAKES ARE FULLY APPLIED.

Answer 33

1/3

Question 34

MOTORCYCLES MAY BE EQUIPPED WITH MEANS OF MODULATING THE HIGH BEAM OF THEIR HEADLIGHTS BETWEEN HIGH AND LOW BEAM AT A RATE OF _____ FLASHES PER MINUTE.

Answer 34

200-280

Question 35

ON MOTORCYCLES MANUFACTURED PRIOR TO ______, THE ACTIVATION OF THE FRONT WHEEL BRAKE IS NOT REQUIRED TO ACTIVATE THE STOP LAMP.

Answer 35

JANUARY 1, 1972

Question 36

INSPECT AND REJECT IF: ANY MOTORCYCLE IS EQUIPPED WITH A TIRE THAT HAS A TREAD DEPTH MEASURING LESS THAN ____.

Answer 36

2/32

Question 37

INSPECT AND REJECT IF: ANY MOTOR VEHICLE, TRAILER, SEMITRAILER, OR OTHER VEHICLE IS NOT EQUIPPED WITH _____ LAMPS IF THE VEHICLE IS OVER _____ FEET WIDE OR IF ANY PORTION EXTENDS ____ INCH(ES) OR MORE OUTSIDE THE FRONT FENDER LINE.

Answer 37

CLEARANCE 7 4

Question 38

TRAILERS HAVING AN ACTUAL GROSS WEIGHT OF LESS THAN ____ LBS ARE NOT REQUIRED TO BE EQUIPPED WITH BRAKES, HOWEVER IF BRAKES ARE INSTALLED, THESE VEHICLES MUST BE _____.

Answer 38

3,000 | INSPECTED

Question 39

INSPECT AND REJECT IF: WHEN TESTED ON DRY, HARD, APPROX LEVEL ROAD FREE FROM LOOSE MATERIAL, AT A SPEED OF __ MPH WITHOUT LEAVING A __-FOOT WIDE LANE, RESULTS IN EXCESS OF THE FOLLOWING DISTANCES ARE OBTAINED: ANY MOTOR VEHICLE (EXCEPT MOTORCYCLES, TRUCKS, AND TRACTOR-TRUCKS WITH TRAILERS ATTACHED) FOUR WHEEL BRAKES - __ FEET; ANY MOTOR VEHICLE (EXCEPT MOTORCYCLES, ETC) TWO WHEEL BRAKES - __ FEET; ALL COMBINATIONS OF VEHICLES - __ FEET.

Answer 39

``` 20 12 25 45 40 ```

Question 40

ALL TRAILERS HAVING AN ACTUAL GROSS WEIGHT OF _____ OR MORE SHALL BE EQUIPPED WITH OPERATIONAL BRAKES ACTING ON ___ WHEELS.

Answer 40

10,000 | ALL

Question 41

INSPECT AND REJECT IF: NONSTEERING AXLES - LINING HAS A THICKNESS LESS THAN __ INCH AT THE SHOE CENTER FOR AIR DRUM BRAKES, __ INCH OR LESS AT THE SHOE CENTER FOR HYDRAULIC AND ELECTRIC DRUM BRAKES AND LESS THAN __ FOR AIR DISC BRAKES, LINING WITH A THICKNESS LESS THAN __ INCH FOR A SHOE WITH A CONTINUOUS STRIP OF LINING OR TO WEAR INDICATORS IF EQUIPPED.

Answer 41

1/4 1/16 1/8 3/16

Question 42

INSPECT AND REJECT IF: ANY MOTORCYCLE MANUFACTURED AFTER ______ IS NOT EQUIPPED WITH EITHER A SPLIT SERVICE BRAKE SYSTEM OR TWO INDEPENDENTLY ACTUATED SERVICE BRAKE SYSTEMS WHICH SHALL ACT ON THE FRONT AS WELL AS THE REAR WHEELS.

Answer 42

JULY 1, 1974