TEST 3 Flashcards
What is a disadvantage of using multilayer switches for inter-VLAN routing?
What is a disadvantage of using router-on-a-stick inter-VLAN routing?
A network administrator enters the following command sequence on a Cisco 3560 switch. What is the purpose of these commands?
Switch(config)# interface gigabitethernet 0/1
Switch(config-if)# no switchport
When configuring a router as part of a router-on-a-stick inter-VLAN routing topology, where should the IP address be assigned?
What is the meaning of the number 10 in the encapsulation dot1Q 10 native router subinterface command?
Which sentence correctly describes the SVI inter-VLAN routing method?
You are troubleshooting an inter-VLAN issue on a router and need to verify the status and IP address of all interfaces in a condensed format. Which inter-VLAN routing troubleshooting command would you use to do this?
What operational mode should be used on a switch port to connect it to a router for router-on-a-stick inter-VLAN routing?
While configuring inter-VLAN routing on a multilayer switch, a network administrator issues the no switchport command on an interface that is connected to another switch. What is the purpose of this command?
You are troubleshooting an inter-VLAN issue on a router and need to verify the status of an access port and its access mode VLAN. Which troubleshooting command would you use to do this?
