Tech Flashcards
What are the basic functions for pushbuttons on overhead panel if pressed in and
when pressed out?
What do the Various colours signify on the Pushbutton Switches on the Overhead Panel?
Where in the cockpit are the Secondary Circuit Breakers installed?
Name the featured areas on Main Instrument Panel?
Name the various panels on the Pedestal?
Why are OEBs issued?
What do you understand by a RED OEB and WHITE OEB?
Can the pilot seats be adjusted if the electrical control fails? If yes, how?
List all the memory items (Memory Procedures) on the A320?
List callouts for following Memory Procedure?
What is the Minimum Runway Width (in meters) for a 180o turn?
What is the Maximum “demonstrated” Crosswind for T/O and Landing?
38kt including gusts
What is the Maximum Runway Slope?
+/- 2%
What is the maximum operating speed VMO/MMO?
350kt / M0.82
What is the maximum ground speed?
195 kt
The maximum service ceiling for the A320 is?
LIM-AG-OPS
39,800ft
What is the effect of ‘Both FWC fault’ on the ECAM warning and caution indication?
What is the effect of ‘Both FWC fault’ on the ECAM warning and caution indication?
After a single DMC failure, how would a crew member recover the lost display unit?
What do you see if DMC 1, 2, or 3 Fail?
What should you do if both ECAM Screens fail?
What happens if the CAPT’S LEFT EFIS Screen fails? How can the ND be Displayed?
What indications will trigger the following: advisory, L1, L2, L3 cautions and warning
If only one ECAM Display Unit is operative, how is an advisory brought to the
attention of the crew?
What is meant by Independent, Primary and Secondary failures?
Explain the meaning of the following audio indications: CRC, single chime, triple click, cricket, continuous buzzer
What is the meaning of - T/O and LAND INHIBIT (magenta memo)? When are they Displayed?
When does the T/O MEMO and LDG MEMO appear on the EWD?
Which SD will appears in following situations –
When is the STS SD called up automatically (other than during an ECAM drill)?
What is the effect of pressing the RCL pushbutton on ECP (ECAM control panel)?
When should the EMER CANC button be used?
What effect does the EMER CANC pb on the ECP have on the Warnings and
Cautions?
What is the effect of Pressing the T/O CONFIG Button?
In single ECAM screen operation, how can an S.D. be displayed and for how long?
How does the ALL button work on ECP? How can the SD system pages be selected
when the ECAM control panel fails?
