Table 4 New Study Guide

Question 1

What is the distance of the blast hazard exclusionary zone referring to toxic gas

Answer 1

295ft

Question 2

The ECH must be in which position for the ECS to be able to remotely move the launcher

Answer 2

Rotate

Question 3

Damage to personal or equipment is what safety

Answer 3

Caution

Question 4

All PAC-3 MSE cables are supplied with an O-ring on the exterior of the connection. If the O-ring is not properly positioned on the connector, foreign material will accumulate rendering the cable unusable. What type of safety is this?

Answer 4

Caution

Question 5

What is the proper way to ground a PAC-3 MSE stack

Answer 5

Must be ground in vertical pairs through the base

Question 6

T/F the launcher should be placed at least 120m in front of the radar

Answer 6

True

Question 7

What form is used to record launcher location and Alignment

Answer 7

DA form 7616

Question 8

What must the torque wrench be set to to torque the missile bolts down

Answer 8

60ft/lb

Question 9

The distance you have to evacuate from a damaged or dropped live can

Answer 9

1250ft

Question 10

If the DHI is 31 or above you should do what

Answer 10

Replace the desiccant

Question 11

Do not crank the generator more than what amount of seconds

Answer 11

15sec

Question 12

Outriggers should be operated in what way to prevent twisting the launcher?

Answer 12

Front pair, rear pair, curbside, roadside

Question 13

A launcher must be level within how many degrees

Answer 13

10 degrees

Question 14

T/F to prevent a missile launch the connect/disconnect switch must be set to disconnect.

Answer 14

True

Question 15

Launching station must be located within how many KM’s and with in the sector limits of what degrees from the PTL

Answer 15

1.3km and 80 degrees

Question 16

How high should the outrigger pads be off the ground to preform a jerk test

Answer 16

Just off the ground (1-2in)

Question 17

What gunnery table do you first conduct missile reload

Answer 17

Table 3

Question 18

What is the travel speed of the ground guide during forklift reload

Answer 18

Walking pace

Question 19

Forks must not be how many inches passed the can when placing the the can on the launcher

Answer 19

6 inches

Question 20

The ECS can rotate the launcher after it’s been put into remote after how many seconds

Answer 20

60sec

Question 21

T/F forklift reload can be preformed from MSA, GMT, or a Flatbed carrier

Answer 21

True

Question 22

How long do you have to complete emplacement

Answer 22

25mins

Question 23

What is the load capacity of the atlas forklift

Answer 23

10,000lb

Question 24

What are the two forms of communication the launcher has with the ECS

Answer 24

Fiber and VHF

Question 25

How often should you check the DHI on stored cans

Answer 25

Weekly

Question 26

What does ELES stand for

Answer 26

Enhanced Launcher Electronic System

Question 27

What information does the INFS provide the ECS

Answer 27

Roll and Cross-roll

Question 28

What is table 1

Answer 28

Basic System Skills

Question 29

T/F missile heat time must be reported to the ECS

Answer 29

True

Question 30

What must the radios data rate be

Answer 30

16000

Question 31

What steps can the operator do to ensure the FOCA is functional

Answer 31

A loop back test, light test, and PMCS fiber head and internal sleeve

Question 32

What drill number covers PAC-3 prepare for movement

Answer 32

44-Cw-D0200

Question 33

What is the launcher back blast area

Answer 33

90m

Question 34

How long do you have to do missile reload

Answer 34

60min

Question 35

What light do you check to see if the fiber is communicating with the ECS

Answer 35

Link

Question 36

T/F the maps supplies power to the dagr and infs

Answer 36

True

Question 37

During manual emplacement how far does the aiming circle have to be from the hub stake

Answer 37

30ft

Question 38

A ground must be placed within how many feet of the the launcher

Answer 38

15ft

Question 39

What table do you conduct ready for action drills

Answer 39

Table 2

Question 40

T/F if one hinge pin is broken on the gmt it is NMC

Answer 40

True