TA Steps

Question 1

Place ladder pipe in service

Answer 1

Rotate turntable, align arrow and check alignment
Lower ladder 3 feet above tiller cage
Rotate ladder to one side and lower into position to attach the ladder pipe

Question 2

Preparing to hoist Aerial ladder with ladder pipe

Answer 2

Attache ladder pipe assembly to top fly section
Position ladder pipe control arm
Connect hose to ladder pipe and attach guide lines
stretch guide lines to a safe area on turntable, opposite side from pedestal

Question 3

Place ladder in position to use ladder pipe

Answer 3

Raise to 70 degrees
Tie 3” hose to bottom of top fly with utility rope Hook passed under rung and hooked on rung above hook facing you
Extend to desire height
call for water

Question 4

Return Aerial ladder to Bed

Answer 4

Calls for water to be shut down
drain hose lines using clapper valve
retract ladder all the way
Release utility rope
Rotate turntable, align arrows and check
Lower ladder 3' above cage, rotate to one side of tiller and lower to remove adder pipe
remove guide lines, hose, ladder pipe
hoist ladder to 4" above cage
Rotate turntable, align arrows
Check allignment
Lower ladder into bed, and settle
Zero out pressure

Question 5

When making Aerial ready to drive, when retracting jacks

Answer 5

Start on high side, lower a few inches then switch to low side and lower a few inches… repeat until fully retracted to prevent binding

Question 6

Making Aerial ready to drive, in Cab

Answer 6

Foot on brake pedal
Confirm “Jack not Nested” light not illuminated
Confirm transmission in Neutral
PTO to off position
-brake lock off
Remove wheel chocks on wheel, release tractor brake

Question 7

What is the normal Hz reading on the generator when supplying power?

Answer 7

60-61 Hz

Question 8

What is the normal operating temperature of the Harrison generator?

Answer 8

Between 140 and 160 degrees F

Question 9

How many KW does the Harrison generator produce

Answer 9

10 KW

Question 10

What is the maximum line amperage for line 1 or line 2 on the quad gauge?

Answer 10

40 AMPS

Question 11

Placing Generator In Service

1 Quartz light and 1 Small smoke ejector

Answer 11

Neutral
engine rpm less than 1200
engage PTO
engage High Idle
Generator operates at 59-61 HZ on the Quad Gauge
Activate generator switch to "On"
Load Switch from "No Load" to "Load"
power turned on for lights and smoke ejector