Systems Check Memorization Stuff

Question 1

Successful RADALT Test

Answer 1

• 5 +/-1 beeps
• Indicator at 100 +/-10 for 5 seconds
• Yellow tape displayed

Question 2

Successful TACAN test

Answer 2

• BRG 1 needle swings to 180* +/-3* for 5 seconds
• DME=0.0 +/-0.5 no
• Deviation bar centered within 1/2 dot
• TO flag if CRS 180, FROM flag if CRS 360

Question 3

Successful Transponder Test

Answer 3

Absence of IFF cautions or advisories

Question 4

Primary Servos Check

Answer 4

• SAS 1 and 2 OFF
• Pilot 1st OFF, observe caution
• Copilot 2nd OFF, observe no new cautions
• Copilot back to center
• Pilot 2nd OFF
• Pilot back to center
• Repeat with copilot leading
• 1st off, Pilot controls
  
  • Pedals centered
  • Collective full up, slow box
  • Running man
  • Collective full up in 2 seconds
• 2nd off
  
  • Running man
  • Collective full up in 2 seconds
• Switch centered

Question 5

Boost Servos Check

Answer 5

• Collective midposition, pedals slight right
• SAS/BOOST - OFF
• Running man, not increased forces except for roll
• Collective midposition, pedals slight right
• SAS/BOOST - ON
• Collective full down

Question 6

Tail Rotor Servo Check

Answer 6

• TAIL SERVO switch - BKUP
• Note #1 TAIL RTR SERVO caution and #2 TAIL RTR SERVO ON advisory
• TAIL SERVO switch - NORM
• Note caution and advisory disappear

Question 7

AFCS Ground Check

-SAS Check

Answer 7

• CMPTR PWR/RESET and SAS/BOOST - Check ON
• TRIM and AURO PLT - Check OFF
• SAS 1 ON for at least 10 seconds, then OFF
• SAS 1 ON, then OFF, observe no movement
• SAS 2 ON, then OFF, observe no movement

Question 8

AFCS Ground Check

-Trim Check

Answer 8

• TRIM ON, then OFF
• TRIM ON
• Pilot controls
• • movement, checking for increased force further out
• Collective midpoint, pedals center
  
  • Check force gradient for collective, pedals
• Set collective, cyclic with trim buttons and ensure they stay
• 4-way TRIM switch analog stick check

-Repeat trim set and 4-way switch check with copilot controls

Question 9

AFCS Ground Check

-Autopilot Check

Answer 9

• SAS 1, SAS 2, TRIM - ON
• AUTO PLT - ON then OFF, observe no movement
• AUTO PLT - ON
• Running Man

Question 10

AFCS Ground Check

-Stabilator Check

Answer 10

• Confirm indicator reads between 34* and 42*
• STABILATOR AUTO CONTROL - ON
• Press STABILATOR TEST button until movement stops (5-12* up), STABILATOR caution appears
• STABILATOR AUTO CONTROL - ON, slews back to 34-42
• MAN SLEW stab up until 5-10
• MAN SLEW stab down to 0*
• STABILATOR AUTO CONTROL - ON, slews back to 34-42