SV Landing Gear Flashcards
Wheel brake temperatures are displayed: [8.140.10]
C. On the gear synoptic
During takeoff, RTO autobraking will not occur unless groundspeed is above: [8.140.10]
A. 85 knots
During landing, auto brake application begins: [8.140.10]
A. When both thrust levers are retarded to idle.
C. With wheel spinup.
D. A and C.
Select the TRUE statement about alternate gear extension. [8.140.10]
A. The landing gear free falls to the down and locked position
How do you know that the parking brake is set? [8.140.10]
B. The EICAS memo message PARKING BRAKE SET is displayed
Which autobrake mode provides the highest deceleration rate for landing? [8.140.10]
D. MAX AUTOBRAKE
Which of the following is true regarding gear down and locked sequence: [8.140.10]
A. Hydraulic pressure unlocks the uplocks, gear falls by gravity, hydraulic pressure closes the gear doors.
The landing gear speed limits for all configurations and modes are . [8.140.20]
B. 270 / .82
Hydraulic power for gear retraction and extension is supplied by the: [8.140.10]
D. Center hydraulic system
If an RTO is initiated below 85 knots groundspeed, the RTO autobrake function: [8.140.10]
A. Does not operate
Which of the following will disarm the autobrake system and cause the EICAS “AUTOBRAKE” advisory message to display? [8.140.10]
A. Selection of the Autobrake switch to Disarm.
B. Loss of IRSs.
C. RTO is initiated above 85 knots, but autobraking has not been applied.
D. All of the above
The autobrake system disarms if: [8.140.10]
A. Pedal braking is applied.
B. Either thrust lever is advanced. C. An antiskid system failure occurs.
D. All of the above
What does the alternate landing gear extension system use to extend the gear? [8.140.10]
A. A dedicated DC hydraulic pump and center hydraulic system fluid
What is provided by the RTO function of the autobrake system? [8.140.10]
C. The RTO function automatically applies maximum brake pressure when the thrust levers are retarded to idle above 85 knots groundspeed
If center hydraulic system fluid quantity is low, is it likely that the gear actuation system has lost all available pressure sources? [8.140.10]
A. No, if center hydraulic system fluid quantity is low, the center system fluid is isolated to provide an alternate extension source.