Status lights Flashcards
RPM
changes to red when rpm falls below min set rpm (3400) in Controller Configuration
ALT
turns red when a/c descends below or climbs above min and max alt as set in mission limits window. also will turn red when aircraft does opposite of commanded.
IAS
turns red when a/s falls below or exceeds min and max a/s set in Controller config (min 33, max 60)
ATT
turns red when the a/c exceeds 25deg of bank or 25deg/sec roll rate. set in Controller config
SYS
turns red if voltages or temps exceed limits set in display settings. 0-80deg C or 11.25-18.5
GPS
turns red if PDOP is >5 or less than 4 Sat. PDOP is set in display settings
LINK
turns red if RSSI or Ack ratio exceed limits (-95 to 85) found in display settings
COMM
turns red when telemetry is not recieved within 10 sec. Either have it or you don’t.
TER
proximity alarm based on a/c velocity in 3D space. green to yellow when 45sec from impact and yellow to red when 25 from impact
SPC
changes from green to yellow when 45 sec from violating a/s and yellow to red when 25 from violating a/s. can be changed in alarm limits
Aero T
turns red when the autopilot commands the termination of the a/c. found in mission limits
DMan On
turns red when the signal from the autopilot to the ecu is interrupted or broken.
Nav
red when in AHRS (attitude heading reference system)