Show Me Questions Flashcards
Show me/explain how you would check that the power assisted steering is working before starting a journey
If the steering becomes heavy, the power assisted steering may be faulty. Before starting a journey two simple checks can be made:
1)Gentle pressure on the steering wheel, maintained whilst the engine is started, should result in slight but noticeable movement as the system begins to operate.
2)Turning the steering wheel just after moving off will give an immediate indication that the power assisted steering is functioning correctly.
Steering should be very easy as the car begins to move off if all is working as it should
Show me how you would check that the horn is working (off road only).
Press the horn and listen (turn on ignition if necessary).
Show me how you would check that the brake lights are working on the car (examiner can help).
Whilst pressing the brake pedal, make use of reflections in windows, garage doors, etc. Or ask someone to help (the examiner). (may need to switch ignition on, prompt not to start engine)
Show me how you would check that the direction indicators are working correctly.
Activate the indicators or hazard warning lights and walk around the car to see if all the indicators are working correctly. Operating the hazard warning lights is the preferred method as the ignition will not need to be switched on.
Show me how you would check the hand (parking) brake for excessive wear.
. Firmly apply the foot brake to secure the car and apply the parking brake. When it is fully applied it should secure itself and not be at the end of its working travel. (Should be tension whilst lifting as the cable connecting the brakes to the lever tighten.)
Show me how you would clean the windscreen using the windscreen washer and wipers.
Operate control and hold for approximately 3 seconds to wash and wipe windscreen (turn ignition on if necessary). If asked this question on a driving test, ensure your windscreen is left clean after the initial clean. Sometimes 2 or 3 cleans are necessary.
Show me how you would set the demister controls to clear all the windows effectively, this should include both front and rear screens.
Set all relevant controls including; fan, temperature, air direction / source and heated screen to clear windscreen and windows. Engine does not have to be started for this demonstration.
Show me how you switch your headlight from dipped to main beam and explain how you would know the main beam is on whilst inside the car.
Operate switch (with ignition or engine on if necessary), check with main beam warning light
Show me how you would switch on the rear fog light(s) and explain when you would use it/them. (No need to exit vehicle).
. Operate switch (turn on dipped headlights and ignition if necessary). Check warning light is on. Explain that fog lights must only be used in foggy, low visibility conditions and must be turned off when fog disperses.
