RP8 - Waves - Part 1: Observing water waves in a ripple tank. Flashcards

1
Q

What is a ripple tank?

A

A shallow glass tank with an oscillating paddle/needle to create waves. It is illuminated from above so the waves can be seen on the surface below the tank.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Outline the basic steps of the practical.

A
  1. Set up the ripple tank with a lamp above it and white card/paper below it
  2. Switch on the motor attached to the wooden rod
  3. Measure the wavelength of the waves being cast onto the card
  4. Count the number of waves passing a point in 10 seconds and calculate the frequency
  5. Calculate the wave speed
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Approximately how much water should you put into the ripple tank? What would the consequence of too much be?

A

The water should be poured to a depth of around 5 mm. If there is too much water the rod won’t produce clear waves and they will be less clearly projected onto the card below.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

How should the wooden rod be set up in the ripple tank?

A

The wooden rod should be placed into the tank so that it just touches the surface of the water.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

How should you measure the wavelengths of the waves on the card?

A
  1. Adjust the lamp position so that the waves are clearly projected onto the card
  2. Using a metre rule, measure across as many waves as you can
  3. Divide the distance by the number of waves
    measured across
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What units should your measured wavelength be in?

A

Metres, m.

(It may be easier to measure in cm, but wavelength must be in m for the wave equation).

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Why should you measure across more than one wave?

A

To reduce the uncertainty in the measurement and improve the accuracy of the value.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

How do you measure the frequency of the waves on the card?

A
  1. Count the number of waves passing a chosen point in 10 secs
  2. Divide the number by 10, to produce a frequency in Hz
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What equation is used to calculate wave speed?

A

Wave Speed = Frequency x Wavelength

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

When the frequency is in Hertz and the wavelength is in metres, what is the unit for wave speed?

A

m/s

Metres per Second

How well did you know this?
1
Not at all
2
3
4
5
Perfectly