Router Show Commands Flashcards
Displays all access lists from all protocols present in a specified router.
show access-list
Displays the banner set on the router
show banner
Shows the status of CDP such as holdtime value, # of packets for every 60sec
show cdp
It tells the CDP configuration on an interfaces-by-interface basis.
show cdp interface
Displays info on directly connected neighbors
show cdp neighbor detail
Displays the cdp traffic info
show cdp traffoc
Displays the clock (time, date)
show clock
Used to view all IOS images and file stored in flash (Default location of IOS images is in flash
show flash
What command will display the signaling specification and number of invalid messages sent on an interface?
show frame-relay lmi
What command will display the PVC status and the DLCI number’s relationship to a destination address?
show frame-relay map
What command will display the PVC status, DLCI number statistics, and local interface statistics?
show frame-relay pvc
Shows the previously executed commands. (IOS device stores the last ten commands that are executed)
show history
Displays the host table
show hosts
To view interfaces, status and statistics for an interface. (If you don’t list a specific interface, all of the interfaces on the router are listed.)
show interfaces
Show the list of eigrp neighbors that a specified router has
show ip eigrp neighbors
Displays the list of successor and feasible successors, as well as other types of routes
show ip eigrp topology
It shows the information about traffic statistics for eigrp
show ip eigrp traffic
Displays the status and global parameters associated with the interfaces on the router.
show ip interfaces
Display the interface operational status and IP addresses for all router interfaces.
show ip interface brief
Displays NAT statistics
show ip nat statistics
Display the NAT translations
show ip nat translations
Display general information about OSPF routing processes
show ip ospf
Displays lists of information related to the OSPF database for a specific router.
show ip ospf database
If adjacent router’s don’t become neighbors then use the command to check if the local router interface is configured correctly
show ip ospf interface
Displays the OSPF neighbor information
show ip ospf neighbor
Displays all OSPF neighbors in detail
show ip ospf neighbor detail
Displays the IP routing table
show ip route
Displays the IP routing table
show ip route
Displays the routing protocols that have been configured and running on a specified router
show protocols
Shows the current config stored in RAM
show running-config
Shoe the telnet sessions that are currently suspended
show sessions
Shows the configuration stored in NVRAM
show startup-config
Displays the version information for the hardware and firmware
show version
Displays entries in the ARP table.
show arp
Displays entries in the ARP table.
show arp
Displays parameters and current state of the active routing protocol process
show ip protocols
Displays users connected to the router
show users
Displays IPv6 interface configuration information
show ipv6 interface
Displays information about all current IPv6 RIP processes
show ipv6 rip
Displays general information about OSPF routing processes
show ipv6 ospf
Displays routes in the IPv6 routing table
show ipv6 route
Displays parameters and current stat of the active IPV6 routing protocol processes
show ipv6 protocols
Displays IP addresses assigned to the clients
show ip dhcp binding
What command displays connections statistics for both the sending and receiving side of a PVC?
show frame-relay end-to-end keepalive
