RME 2-A

Question 1

SI unit of potential difference.

Answer 1

Volt

Question 2

Which of the following conditions do NOT have to be met by alternators working in principle?

A. terminal voltage of each mavhine must be the same
B. machines must have the same phase rotation
C. alternators must operate at the same frequency
D. the machines must have equal KVA rating

Answer 2

D. the machines must have equal KVA rating

Question 3

The ampacity of the phase conductors from generator terminals to the first over current device shall not be less than ___ percent of the nameplate current rating of the generator

Answer 3

115

Question 4

If a live conductor is connected accidentally, the severity of the electrical shock is determined primarily by _____.

Answer 4

the contact resistance

Question 5

If the potential across a circuit is 40 V and the current is 5, 000 mA, what is the equivalent resistance of the circuit?

Answer 5

8 ohms

Question 6

If the voltage rotation of a three-phase motor us A-B-C, the current rotation is _____

Answer 6

B-C-A

Question 7

Unit of electric charge.

Answer 7

Coulomb

Question 8

All the conductors in a multi wire branch circuit shall originate from the same ______.

Answer 8

panelboard

Question 9

In a parallel circuit, the total resistance is ________.

Answer 9

smaller than the smallest resistance in the combinations

Question 10

Each service disconnecting means shall ________ disconnect all ungrounded service conductors from the premises wiring system.

Answer 10

simultaneously

Question 11

Which of the following gases is given off by lead-acid storage batteries?

Answer 11

hydrogen

Question 12

The minimum wire bending space within the enclosure for motor controllers for a 1/0 conductor (2 wires per terminal) would be _____ mm.

Answer 12

130 mm

Question 13

MI cable shall be permitted ______.

I. As feeder and branch circuits
II. For wet and dry locations
III. For concealed or exposed

Answer 13

I, II and III

Question 14

Underground service conductors carried up a pole must be protected from mechanical injury to a height of at least _____ feet.

Answer 14

8 feet

Question 15

________ is the ability of a material to permit the flow of electrons.

Answer 15

Conductance

Question 16

Coaxial cables for a fire alarm system shall be permitted to have copper covered steel center conductors with a minimum of 30 percent copper shall be listed as type _______.

I. FPL
II. FPLR
III FPLS
IV FPLP

Answer 16

I, II and IV only

Question 17

A passive element in a circuit is the one that ______ the energy.

Answer 17

receives

Question 18

To qualified applicants for examination, notice of admission shall be issued not later than _______ days prior to the first day of examination.

Answer 18

10

Question 19

Only wiring method recognized as _______ are included in the code

Answer 19

Suitable

Question 20

A piece if electrical equipment that is designed to operate at alternate intervals of (1) load and no load; or (2) load and rest; or (3) load, no load, and rest is called _________ duty.

Answer 20

Intermittent

Question 21

What is the ohmic value of resistor having the color bands: brown, green, red, and gold?

Answer 21

1.5 kiloohms

Question 22

Voltage between the hot (undergrounded) conductors in FCC cable shall not exceed ______ volts.

Answer 22

300

Question 23

A _____ is a protective device for limiting surge voltages by discharging or bypassing surge current and it also prevents continued flow of follow current whole remaining capable if repeating these functions

Answer 23

Surge arrester

Question 24

A clamp-on ammeter will measure ______.

Answer 24

Accurately only clamped perpendicular to a conductor

Question 25

The terminal voltage of this dc generator varies widely when a change in load occurs. Which one of this?

Answer 25

Series

Question 26

Expired license shall be renewed only after complying the required CPE units. What does CPE stands for?

Answer 26

Continuing Professional Education

Question 27

In general, the most important point to watch in the operation of transformers is the ______.

Answer 27

Temperature

Question 28

If a 10 ohm, a 20 ohms, and a 30 ohms resistor are connected in series across a 120 volt source, the voltage across the 20 ohm resulted will be ______ volts.

Answer 28

40

Question 29

A bare copper conductor can be used in an underground service _____ . A. Where judged suitable for soil conditions B. Where used in raceway C without regard to soil conditions where part of cable assembly D. All of the above

Answer 29

D. All of the above

Question 30

Size 18 or 16 fixture wires, and flexible cords shall be permitted for the control and operating circuits of X-ray and auxiliary equipment where protected by not larger than ______ ampere overcurrent devices.

Answer 30

20

Question 31

Conductors supplying outlets for arc or Xenon projectors of the professional type shall not be smaller than _____

Answer 31

8

Question 32

The feeder conductor shall not be lower than that of the service-entrance conductors where the feeder conductors carry the total load supplied by service-entrance conductors with an ampacity of _______ amperes or less

Answer 32

55

Question 33

You shouldn’t use a file without a handle because ____

Answer 33

The user may be injured

Question 34

Any member the Board of Electrical Engineering may be removed by the _______ for neglect of duty, incompetence, malpractice, irregularities in the examinations, for unprofessional, unethical or dishonorable conduct, after having been given the opportunity to defend himself in a proper administrative investigation

Answer 34

President of the Republic of the Philippines

Question 35

A show window is calculated at _____ VA per linear foot.

Answer 35

200

Question 36

A commutator is ________

Answer 36

A device for causing the alternating currents generated in the armature

Question 37

A resistor of 6 ohms is connected in series with a 6-ohm resistor. What resistance must be placed across the 6-ohm resistor so that the total resistance shall be 7 ohms?

Answer 37

3 ohms

Question 38

Concrete, brick, or tile walls are considered as being _____

Answer 38

Grounded

Question 39

If the primary winding of a 10 to 1 step down transformer has 20 000 turns, the secondary winding should have _____ turns

Answer 39

2000

Question 40

Resistance opposes the flow of current in a circuit and it measured in ____

Answer 40

Ohms

Question 41

This tool is used to cut away the rough edges inside the end of the pipe after it has been cut with a cutter

Answer 41

Reamer

Question 42

Underground flat-top raceways over 4 inches but not over 8 inches wide with a minimum of 1 inch spacing between raceways shall be covered with concrete to a depth of not less than ______

Answer 42

1”

Question 43

Where the constant speed is required, the motor should be a _____

Answer 43

Compound motor

Question 44

Liquid tight flexible metal conduit may be used in which if the following locations?

Answer 44

In connection areas for gasoline dispensing pumps

Question 45

Infrared lamps for industrial heating appliances shall have over current protection not exceeding ____ amps.

Answer 45

50

Question 46

Conduit installed in a concrete slab is considered a ______.

Answer 46

Wet location

Question 47

Which of the following locations is not permitted for the use of surface raceways?

Answer 47

Hoist ways

Question 48

Induction heating coils that operated or may operate at a voltage greater than 30 volts AC shall be _____ to protect personnel in the area. I. Isolated II. Made inaccessibility by location III. Enclosed in a non-metallic enclosure IV. Enclosed in a split metallic enclosure

Answer 48

I, II, III and IV

Question 49

_______ raceways are not suitable to enclose conductors that are subject to physical damage.

Answer 49

PVC schedule 40

Question 50

What limits the size of an induction motor that can be started across the line

Answer 50

Horsepower rating