Required practical 8 - Waves: Part 1 - Observing water waves in a ripple tank Flashcards
What is a ripple tank?
A shallow glass tank with an oscillating paddle/needle to create waves. It is illuminated from above so the waves can be seen on the surface below the tank.
Outline the basic steps of the practical
1) Set up ripple tank with a lamp above it and white card/paper below it.
2) Switch on the motor attached to the wooden rod.
3) Measure the wavelength of the waves being cast onto the card.
4) Count the number of waves passing a point in 10 seconds and calculate frequency.
5) Calculate wave speed.
Approximately how much water should you put into the ripple tank? What would the consequence of too much be?
The water should be poured to a depth of 5mm. If there is too much water, the rod won’t produce clear waves and they will be less clearly projected onto the card below.
How should the wooden rod be set up in the ripple tank?
The wooden rod should be placed into the tank so that it touches the surface of the water.
How should you measure the wavelength of the waves on the card?
1) Using a meter ruler, measure across as many waves as you can.
2) Divide the distance by the number of waves ,measured across.
What units should your wavelength be in?
Meters (m).
It may be easier to measure in cm, but wavelength must be in m for the wave equation
Why should you measure across more than one wave?
To reduce the uncertainty in the measurement and improve the accuracy of the value.
How do you measure the frequency of the waves on the card?
1) Count the number of waves passing a chosen point in 10 seconds.
2) Divide the number by 10, to produce a frequency in Hz.
What equation is used to calculate wave speed?
Wave speed = frequency x wavelength
When the frequency is in Hertz and the wavelength is in meters, what is the unit for wave speed?
m/s.