Quiz 4 Flashcards

1
Q

All exterior footings shall be placed a minimum of ____ inches below the undisturbed ground.

A

12

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

A two-story conventional light frame dwelling is to be constructed in an area where the load-bearing value of the soil is 2,000 psf. What is the minimum required width of the concrete footings?

A

12 inches

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Air entrainment for concrete subjected to weathering, when required for locations other than garage floors with a steel troweled finish, shall have a total air content of ____ minimum and ____ maximum.

A

5%

7%

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

On graded sites where structures are placed adjacent to slopes steeper than 1:3 the top of any exterior foundation wall shall extend a minimum of ____ above the elevation of the street gutter or other approved drainage discharge point.

A

12 inches plus 2 percent

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

A 9-foot-high plain masonry foundation wall is subjected to 7 feet of unbalanced backfill. If the soil class is GC, what is the minimum required wall thickness?

A

12 inches solid grouted

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

The minimum required thickness for concrete spread footing is what?

A

6 inches

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

A dwelling unit located in an area with an air freezing index of 3500 is constructed with frost-protected shallow foundation. What is the minimum required horizontal insulation R-value at the corners of the foundation?

A

11.2

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

An 8-foot-high 9.5 inches thick concrete foundation walll is subjected to 6 feet of unbalanced backfill. If the soil class is GP, what is the minimum vertical reinforcement?

A

NONE

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

The maximum permitted slope for the bottom surface of footings shall be?

A

1:10

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

Where a permanent wood foundation wall system is used, the wall shall be supported by a minimum ____ footing plate resting on gravel or crushed stone fill a minimum of ___ in width.

A

2 inch by 8 inch

16 inches

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

Where wood studs having an Fb value of 1320 are used in a wood foundation wall, the minimum stud size shall be ____ and the maximum stud spacing shall be ____ on center.

A

2 inches by 6 inches

16 inches

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

Anchor bolts used to attach wood sill plates to foundation walls shall be spaced a maximum of ___ on center.

A

6 feet

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

Where masonry veneer is used, ICF foundation walls shall extend a minimum of ___ above adjacent finished grade.

A

4 inches

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

In order to use frost protected shallow foundations, the monthly mean temperature of the building must be maintained at a minimum of what?

A

64 degrees

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Unless grading is prohibited by physical barriers, lots shall be graded away from the foundation with a minimum fall of ___ within the first ____.

A

6 inches

10 feet

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

What are the minimum and maximum footing projections for a concrete footing having a thickness of 8 inches?

A

2 inches, 8 inches

17
Q

Concrete used in basement slab shall have a minimum compressive strength of ____ where a severe weathering potential exist.

A

2,500 psi

18
Q

Where the foundation wall supports a minimum of _____ of unbalanced back fill, back fill shall not be placed against the wall unit the wall has sufficient strength and has been anchored to the floor above or has been sufficiently braced.

A

4 feet

19
Q

In the absence of a complete geotechnical evaluation to determine the soil’s characteristics clayey sand material shall be assumed to have a presumptive load-bearing value of what?

A

2,000 psf